Reply to thread

Message

<blockquote data-quote="x4mer" data-source="post: 238810" data-attributes="member: 59800">Sorry for the delayI have no need for disecq support anymore, but I'd like to continue, to try to help getting disecq working for these cards in TVE3. I know this is OT for this&nbsp; thread (since it's disecq not 22kHz). I tried to take it to PM, but can't attach logs there.&nbsp;I hooked the disecq switch back up tonight. I'm using 2 legacy dual LNBs. One port of each is hooked to a 22kHz switch, which is working fine now, thanks to you. I've got the remaining port on each now hooked to my 4x1 disecq on ports 2 &amp; 3. I've tempoarily moved the output line from the 22k switch to the disecq switch output. Therefore the 22kHz switch is out of the loop, and only the disecq is involved.&nbsp;In MT I set bird 1 to Commited port2, &amp; bird 2 to Committed port3 (everything&nbsp; works fine in MT). I set TVE3 to the same, &amp; deleted all but 3tps on each bird like you asked. I powered down the PC to cut power to the switch, so it would go to default settings. I then launched TVE3 (V 17500 now), &amp; did a scan of the 3 tps on both LNBs. The switch did not switch, so I got no signal on any of them. Logs are attached.EDIT - Sorry it's an Eaglestar pro disecq switch, &amp; the card is the one mentioned earlier in this thread a Digiwave 103g. The card is a rebadge of a Geniatech Digistar, &amp; uses the Geniatech drivers - the ones on their website.</blockquote>

[QUOTE="x4mer, post: 238810, member: 59800"] [b]Sorry for the delay[/b] I have no need for disecq support anymore, but I'd like to continue, to try to help getting disecq working for these cards in TVE3. I know this is OT for this thread (since it's disecq not 22kHz). I tried to take it to PM, but can't attach logs there. I hooked the disecq switch back up tonight. I'm using 2 legacy dual LNBs. One port of each is hooked to a 22kHz switch, which is working fine now, thanks to you. I've got the remaining port on each now hooked to my 4x1 disecq on ports 2 & 3. I've tempoarily moved the output line from the 22k switch to the disecq switch output. Therefore the 22kHz switch is out of the loop, and only the disecq is involved. In MT I set bird 1 to Commited port2, & bird 2 to Committed port3 (everything works fine in MT). I set TVE3 to the same, & deleted all but 3tps on each bird like you asked. I powered down the PC to cut power to the switch, so it would go to default settings. I then launched TVE3 (V 17500 now), & did a scan of the 3 tps on both LNBs. The switch did not switch, so I got no signal on any of them. Logs are attached. EDIT - Sorry it's an Eaglestar pro disecq switch, & the card is the one mentioned earlier in this thread a Digiwave 103g. The card is a rebadge of a Geniatech Digistar, & uses the Geniatech drivers - the ones on their website. [/QUOTE]

Verification