Reply to thread

Message

<blockquote data-quote="x4mer" data-source="post: 239522" data-attributes="member: 59800">Hi dman_lfc,&nbsp;I e-mailed geniatech, requesting support documentation for adding diseqc control into Mediaportal. They responded with the following &amp; attachment.---------------------------Dear Developer:&nbsp;&nbsp; &nbsp; &nbsp; &nbsp;&nbsp; Here is the DiseQc control sample code. Any question please let me know. &nbsp;------------------------&nbsp;I don't know if the attached will be of use to you or not. Let me know if you would like me to test anything further.x4merP.S. I just used the little utility included in the archive, &amp; using it I could manually enter the freq., pol., A/V PIDS, &amp; then use the diseqc menu to issue diseqc commands. This allowed me to switch between a channel on port 2 &amp; a channel on port 3. I used&nbsp;E0 10 38 F4 for port 2&nbsp;E0 10 38 F8 for port 3</blockquote>

[QUOTE="x4mer, post: 239522, member: 59800"] Hi dman_lfc, I e-mailed geniatech, requesting support documentation for adding diseqc control into Mediaportal. They responded with the following & attachment. --------------------------- Dear Developer: Here is the DiseQc control sample code. Any question please let me know. ------------------------ I don't know if the attached will be of use to you or not. Let me know if you would like me to test anything further. x4mer P.S. I just used the little utility included in the archive, & using it I could manually enter the freq., pol., A/V PIDS, & then use the diseqc menu to issue diseqc commands. This allowed me to switch between a channel on port 2 & a channel on port 3. I used E0 10 38 F4 for port 2 E0 10 38 F8 for port 3 [/QUOTE]

Verification