Reply to thread

Message

<blockquote data-quote="TrevorC" data-source="post: 302397" data-attributes="member: 81273">I have recently done an install of MP with a motorised dish using a VBOX II to convert DiSEqC 1.2 to 36V motor.I was also having problems with the card being locked. (Using a Nova S2). I finally managed to set up the positioning and tuning by doing the following.Use the TVserver DiSEqC controls align the dish to the desired satellite and click the save position button. Click OK to exit with TVserver configuration program without scanning.Kill and restart the TVserver processRe-open the TVserver configuration and go directly to scan. This should then scan the last satellite programmed.Repeat the above procedure for each of the satellites required.I think that the tuner part of the DiSEqC control is not releasing the tuner after you have finished moving and setting up positions.I hope that this makes sense and helps.</blockquote>

[QUOTE="TrevorC, post: 302397, member: 81273"] I have recently done an install of MP with a motorised dish using a VBOX II to convert DiSEqC 1.2 to 36V motor. I was also having problems with the card being locked. (Using a Nova S2). I finally managed to set up the positioning and tuning by doing the following. Use the TVserver DiSEqC controls align the dish to the desired satellite and click the save position button. Click OK to exit with TVserver configuration program without scanning. Kill and restart the TVserver process Re-open the TVserver configuration and go directly to scan. This should then scan the last satellite programmed. Repeat the above procedure for each of the satellites required. I think that the tuner part of the DiSEqC control is not releasing the tuner after you have finished moving and setting up positions. I hope that this makes sense and helps. [/QUOTE]

Verification