Diesqc Settings EMP 9in 4OUT (1 Viewer)

[Joebean]

I have an EMP switch 9 In 4 out. These are the settings I used in mytheatre, and they worked perfectly.

SW: 12200000 <-- 22KHz ON
SW: 12700000 <-- 22KHz OFF

Nimiq 1 - Commited LNB 1 LOF = 11250000 SW= 12200000 LOF2 = 11250000

Nimiq 2 - Commited LNB 1 LOF = 11250000 SW= 12700000 LOF2 = 11250000

Echostar 7 - Commited LNB 2 LOF = 11250000 SW= 12200000 LOF2 = 11250000

Echostar 6,8 - Commited LNB 2 LOF = 11250000 SW= 12700000 LOF2 = 11250000

I cant seem to get any kind of signal whatso ever with TVServer with these settings. I am running just normal/standard LNBs. Does TVServer support 22 KHz switching?

I disconnected the switch completely and ran the line direct to the LNB. Same result, no signal at all. I am using a twinhan 1020 DVB-S card with the BDA drivers. I just cant seem to get the settings right.

As for the EMP switch, its a combination of 22KHz swithcing and Diseqc Switching. That said even if I used a 4-1 diseqc switch, what would the port selection be? I dont understand Level 1 AB AA BA BB...are these supposed to be port numbers?

Any help with any of this would be much appreiciated. Continuing to test....ergg...