I did a huge system upgrade and did a fresh install of MP 1.5. For some odd reason when I go to watch TV my display cuts out (TV says "Mode not supported"). I know TV is working fine because I can preview all my channels in the TV Configuration. It seems like MP is trying to switch my display into an unsupported resolution or something. Any ideas what could be causing this?
Display stops when starting TV (1 Viewer)
- Thread starter ewiles
- Start date
- September 1, 2008
- 21,544
- 8,236
- Home Country
-
New Zealand
At a guess, refresh rate changing...
http://wiki.team-mediaportal.com/1_...figuration/11_General/21_Dynamic_Refresh_Rate
...however, if you want to be sure, I strongly suggest you post log files.
http://wiki.team-mediaportal.com/1_MEDIAPORTAL_1/16_Support/3_Forums/2_Log_Files
- Thread starter
- #3
I will look into it. I never had to adjust these settings with this TV when using an nVidia card. But I now have an ATI card and it started doing this.
- Thread starter
- #4
Refresh rate was the problem. I had to enabled the "notify refresh rate change" and used VNC to see that it was switching to 50Hz. I had to change it to 60Hz and got it working. Thanks for the help!
- September 1, 2008
- 21,544
- 8,236
- Home Country
-
New Zealand
No problem, and thank you for reporting back. Always good to hear when a problem is resolved.