I have installed todays SVN and TV server (Rev 13331).
AC3 sound is working now, however not really reliable.
I have observed the following issues:
1. Sometimes, when opening the "audio popup" in TV mode, the screen shows only "MP1: AC3:" but it is empty! Normally, it should show e.g. "MP1:deu, AC3:deu", so the language is missing. If this happens, AC3 sound is not working, even though is should. If I switch to another channel, where AC3 works and then back to the channel before, then AC3 works as well.
2. It is very annoying that the audio has to be switched manually all the time. Is there any possibility to define the default audio? My idea is that there should be a checkbox within the TV server where you can choose your preffered audio. So if you have a AC3 receiver, you would select "AC3". Then the TV server would choose AC3 audio by default and only, if it is not available then switch back to audio 1.
Hi MPUserFromGER,
1) This has nothing to say. The language is set during the channel scan. I don't have a language in most of my channels.
On some channels it can take up to 3 sec before the stream is changed, so perhaps you have not waited long enough?
2) Well, the decision to implement this up to the devs. Don't know if this is wanted
The only thing that doesn't work in my single seat installation are the TS recordings:
The ts recordings show AC3, but when i switch to the audio stream: no sound?