Just did a complete re-install of TVServer and went to do a DVB-S scan but lots of channels not picked up.
I edited the transponder file to only include the first transponder (which I knew had no channels picked up on). If I scan in MP I just get the no signal error. If I scan this freq in DVBViewer it happily picks up the right channels with 100% signal strength.
Also found a very small error in that I clicked on Diseq tab by mistake in trying to get logs for this. It appears the default setting is for 2E for which there is no transponder file in the tuning parameters folder.
I edited the transponder file to only include the first transponder (which I knew had no channels picked up on). If I scan in MP I just get the no signal error. If I scan this freq in DVBViewer it happily picks up the right channels with 100% signal strength.
Also found a very small error in that I clicked on Diseq tab by mistake in trying to get logs for this. It appears the default setting is for 2E for which there is no transponder file in the tuning parameters folder.