Hello,
My apologizes for not attaching HW config, this simple error is easily reproduceable in any setup. It's been there since the begining, I've just tested it with latest SVN (rev 23684).
To reproduce it:
-Go to screen calibration, set it to anything greater thatn 1 (mine is 1.33)
-Go to My Picures, and look for a picture with aspect ratio "wider" than 4:3
-Fullscreen it, and you'll see black bars all around (left, right, top and bottom)
-If you press "1", it'll fit your screen as it should
You can see pics in this other post.
It's specially anoying when slideshowing... there's no time to press "1" for all pics!
As a side note, there are many 16:9 plasmas and LCDs out there wich have a native 4:3 resolution (i.e. 1024x768). This is why I think screen calibration in MP is just a great feature!
Thanks for your time!
My apologizes for not attaching HW config, this simple error is easily reproduceable in any setup. It's been there since the begining, I've just tested it with latest SVN (rev 23684).
To reproduce it:
-Go to screen calibration, set it to anything greater thatn 1 (mine is 1.33)
-Go to My Picures, and look for a picture with aspect ratio "wider" than 4:3
-Fullscreen it, and you'll see black bars all around (left, right, top and bottom)
-If you press "1", it'll fit your screen as it should
You can see pics in this other post.
It's specially anoying when slideshowing... there's no time to press "1" for all pics!
As a side note, there are many 16:9 plasmas and LCDs out there wich have a native 4:3 resolution (i.e. 1024x768). This is why I think screen calibration in MP is just a great feature!
Thanks for your time!