- Thread starter
- #11
OK, I am still having difficulty getting IRSS to work with my set top box. I have done much since my last post. First I updated to Windows 10, (not that I wanted to, but I wanted to get completely away from Media Center). Then I did a clean install of Win 10. I reinstalled MediaPortal 1. I have everything working, including the guide and all of the channels from my antenna and the cable company.
In MediaPortal I can watch and change the terrestrial channels. When I select a cable channel the set top box is selected, but if I change to a different cable channel the same original channel is showing. There is no blaster working to the set top box. I am using a keyboard to make these changes.
When I installed IRSS I selected: IR Server, MediaPortal plug in, MP Control plug in and MP Blast Zone Plug in. TV Server Plug Ins, TV Server Blaster Plug in. Tools, Abstractor, Debug Client and Translator. I installed IRSS as an application.
In TV Server Configuration I selected Server Blaster and TV3 Blaster plug in. After stopping and starting the service I selected the TV 3 Blaster plug in. My set top box is a Cisco RNG100 from Comcast. This set top box is not listed in the Quick Set up box. I then went to the IR Commands tab to try to input the codes from my set top box remote. Here is where I get stuck. When I click Learn I get an "Learn IR timed out" before I can press any buttons on the remote.
I am including MP logs and the IRSS logs.
Thanks again for your patience with me.
Wayne
In MediaPortal I can watch and change the terrestrial channels. When I select a cable channel the set top box is selected, but if I change to a different cable channel the same original channel is showing. There is no blaster working to the set top box. I am using a keyboard to make these changes.
When I installed IRSS I selected: IR Server, MediaPortal plug in, MP Control plug in and MP Blast Zone Plug in. TV Server Plug Ins, TV Server Blaster Plug in. Tools, Abstractor, Debug Client and Translator. I installed IRSS as an application.
In TV Server Configuration I selected Server Blaster and TV3 Blaster plug in. After stopping and starting the service I selected the TV 3 Blaster plug in. My set top box is a Cisco RNG100 from Comcast. This set top box is not listed in the Quick Set up box. I then went to the IR Commands tab to try to input the codes from my set top box remote. Here is where I get stuck. When I click Learn I get an "Learn IR timed out" before I can press any buttons on the remote.
I am including MP logs and the IRSS logs.
Thanks again for your patience with me.
Wayne