Reply to thread

Message

<blockquote data-quote="Joebean" data-source="post: 191386" data-attributes="member: 58137">9in 4out EMP switchI have an EMP switch 9 In 4 out. These are the settings I used in mytheatre, and they worked perfectly.SW: 12200000 &lt;-- 22KHz ONSW: 12700000 &lt;-- 22KHz OFFNimiq 1 - Commited LNB 1 LOF = 11250000 SW= 12200000 LOF2 = 11250000Nimiq 2 - Commited LNB 1 LOF = 11250000 SW= 12700000 LOF2 = 11250000Echostar 7 - Commited LNB 2 LOF = 11250000 SW= 12200000 LOF2 = 11250000Echostar 6,8 - Commited LNB 2 LOF = 11250000 SW= 12700000 LOF2 = 11250000I cant seem to get any kind of signal whatso ever with TVServer with these settings. I am running just normal/standard LNBs. Does TVServer support 22 KHz switching?I disconnected the switch completely and ran the line direct to the LNB. Same result, no signal at all. I am using a twinhan 1020 DVB-S card with the BDA drivers. I just cant seem to get the settings right.As for the EMP switch, its a combination of 22KHz swithcing and Diseqc Switching. That said even if I used a 4-1 diseqc switch, what would the port selection be? I dont understand Level 1 AB AA BA BB...are these supposed to be port numbers?Any help with any of this would be much appreiciated. Continuing to test....ergg...</blockquote>

[QUOTE="Joebean, post: 191386, member: 58137"] [b]9in 4out EMP switch[/b] I have an EMP switch 9 In 4 out. These are the settings I used in mytheatre, and they worked perfectly. SW: 12200000 <-- 22KHz ON SW: 12700000 <-- 22KHz OFF Nimiq 1 - Commited LNB 1 LOF = 11250000 SW= 12200000 LOF2 = 11250000 Nimiq 2 - Commited LNB 1 LOF = 11250000 SW= 12700000 LOF2 = 11250000 Echostar 7 - Commited LNB 2 LOF = 11250000 SW= 12200000 LOF2 = 11250000 Echostar 6,8 - Commited LNB 2 LOF = 11250000 SW= 12700000 LOF2 = 11250000 I cant seem to get any kind of signal whatso ever with TVServer with these settings. I am running just normal/standard LNBs. Does TVServer support 22 KHz switching? I disconnected the switch completely and ran the line direct to the LNB. Same result, no signal at all. I am using a twinhan 1020 DVB-S card with the BDA drivers. I just cant seem to get the settings right. As for the EMP switch, its a combination of 22KHz swithcing and Diseqc Switching. That said even if I used a 4-1 diseqc switch, what would the port selection be? I dont understand Level 1 AB AA BA BB...are these supposed to be port numbers? Any help with any of this would be much appreiciated. Continuing to test....ergg... [/QUOTE]

Verification