Logitech diNovo mediapad (1 Viewer)
- Thread starter glimtz
- Start date
Users who are viewing this thread
Similar threads
I was installing/upgrading x64 over x86.
These 2 problems did not occur when installing/upgrading x86 over x86.
All is good. Now running 1.35 x86 with no problem.
Thank you
I was installing/upgrading x64 over x86.
These 2 problems did not occur when installing/upgrading x86 over x86.
All is good. Now...
Good day,
2 problems after upgrading to 1.34 from 1.33:
1- To avoid error message TuningParameters not found when starting...
I was installing/upgrading x64 over x86.
These 2 problems did not occur when installing/upgrading x86 over x86.
All is good. Now running 1.35 x86 with no problem.
Thank you
I was installing/upgrading x64 over x86.
These 2 problems did not occur when installing/upgrading x86 over x86.
All is good. Now...
Good day,
Same 2 installation problem as last version.
2 problems after upgrading to 1.35 from 1.34:
1- To avoid error message...
Ok, so perhaps a solution, but not the "right" solution. On the client, within media portal configuration, under TV settings, advanced options, I switched to UNC paths instead of the default RSS, and it's working very well. Sure I had to figure out the paths, but no big deal.
Maybe helpful for someone in the future. Thanks for the...
Ok, so perhaps a solution, but not the "right" solution. On the client, within media portal configuration, under TV settings...
Hi folks. I have an issue with a new install/integration into my mediaportal system. I have a “mediaportal server” which has the TV...
Ran into this problem following an otherwise sucessful upgrade from MP 1.34 x64 to MP 1.35 x64 the CEC Remote plugin which I use just to control volume and standby, will no longer put my devices (TV & AVR) to sleep when the HTPC is put in standby. Also when I wake up the HTPC MP closes or crashes (not sure which) as per the example in...
Ran into this problem following an otherwise sucessful upgrade from MP 1.34 x64 to MP 1.35 x64 the CEC Remote plugin which I use...
Ran into this problem following an otherwise sucessful upgrade from MP 1.34 x64 to MP 1.35 x64 the CEC Remote plugin which I use...
that's awesome, thank you!
problem fixed. no idea how it got changed as I rarely go into the config.
that's awesome, thank you!
problem fixed. no idea how it got changed as I rarely go into the config.
Hi,
until recently i had my tv channels selectable by typing the channel number on my remote. for instance, i hit the number 9...