lost power to LNB from hauppauge 4000 cards (1 Viewer)

[gigabyter64]

Hey Guy's, I have somehow lost power to lnb from my 2 HVR4000 cards in Win7, I know this is the fault because if I turn on spare Sat box on same dish setup the HVR4000's start to work again with power from spare sat box. It's been a while since I have used it & just wondered if media portal had setting for powering on & off lnb or is that more to do with drivers, I have swapped around cables thinking it might be a power pass splitter at fault, but made no difference & surely not both cards are faulty at same time. Any help appreciated, cheers

 

[Paranoid Delusion]

Hi

Try changing the setting "allow cards to be preloaded"

http://wiki.team-mediaportal.com/1_...uration/TV-Server_Configuration/02_TV_Servers

Info in wiki halfway down page, do this for each tuner, should now work, can you let us know if this is the problem as we may have to re=think whether that setting needs to be changed.

 

[gigabyter64]

Hi, have checked this setting & I am already using it "allow cards to be preloaded", btw I am using ver 1.3.0.0, I have not set my cards up as hybrids but I take it this should not matter to LNB power, I can use Terrestrial ok but when switch over to sat they do not go, as i use to use the Sat for epg gragging & recording, as have no Mheg5 compat on cards I cannot record anymore. I know these cards cannot run sat & terrestrial at same time, but they use to work Ok.

 

[gigabyter64]

Bump

Hi, have checked this setting & I am already using it "allow cards to be preloaded", btw I am using ver 1.3.0.0, I have not set my cards up as hybrids but I take it this should not matter to LNB power, I can use Terrestrial ok but when switch over to sat they do not go, as i use to use the Sat for epg gragging & recording, as have no Mheg5 compat on cards I cannot record anymore. I know these cards cannot run sat & terrestrial at same time, but they use to work Ok.