lost power to LNB from hauppauge 4000 cards (1 Viewer)

gigabyter64

MP Donator
  • Premium Supporter
  • June 16, 2009
    20
    0
    Home Country
    New Zealand New Zealand
    Hey Guy's, I have somehow lost power to lnb from my 2 HVR4000 cards in Win7, I know this is the fault because if I turn on spare Sat box on same dish setup the HVR4000's start to work again with power from spare sat box. It's been a while since I have used it & just wondered if media portal had setting for powering on & off lnb or is that more to do with drivers, I have swapped around cables thinking it might be a power pass splitter at fault, but made no difference & surely not both cards are faulty at same time. Any help appreciated, cheers
     

    gigabyter64

    MP Donator
  • Premium Supporter
  • June 16, 2009
    20
    0
    Home Country
    New Zealand New Zealand
    Hi, have checked this setting & I am already using it "allow cards to be preloaded", btw I am using ver 1.3.0.0, I have not set my cards up as hybrids but I take it this should not matter to LNB power, I can use Terrestrial ok but when switch over to sat they do not go, as i use to use the Sat for epg gragging & recording, as have no Mheg5 compat on cards I cannot record anymore. I know these cards cannot run sat & terrestrial at same time, but they use to work Ok.
     

    gigabyter64

    MP Donator
  • Premium Supporter
  • June 16, 2009
    20
    0
    Home Country
    New Zealand New Zealand
    Bump

    Hi, have checked this setting & I am already using it "allow cards to be preloaded", btw I am using ver 1.3.0.0, I have not set my cards up as hybrids but I take it this should not matter to LNB power, I can use Terrestrial ok but when switch over to sat they do not go, as i use to use the Sat for epg gragging & recording, as have no Mheg5 compat on cards I cannot record anymore. I know these cards cannot run sat & terrestrial at same time, but they use to work Ok.
     

    Users who are viewing this thread

    Top Bottom