home
products
contribute
download
documentation
forum
Home
Forums
New posts
Search forums
What's new
New posts
All posts
Latest activity
Members
Registered members
Current visitors
Donate
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Search titles only
By:
Menu
Log in
Register
Navigation
Install the app
Install
More options
Contact us
Close Menu
Forums
MediaPortal 1
Support
Watch / Listen Media
Television (MyTV frontend and TV-Server)
MP 1.6 and HDHomerun Prime - not releasing / deactivating tuners when done.
Contact us
RSS
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="T^2" data-source="post: 1058086" data-attributes="member: 145022"><p>So... Still getting some odd behavior even with the firewall turned off. Most of the time the channel changes are quick in MP. However, occasionally the channel change can take an excessive amount of time. Say Tuner 0 is currently active, command a new channel, and it just waits. While waiting Tuner 1 LED will start blinking and will remain blinking for some time after the channel change finally happens (eventually going out). Tuner 0's LED remains steady the whole time.</p><p></p><p>I noted the following from SD's installation instructions:</p><p></p><p></p><p></p><p>Also note that there are no channel changing issues with the HDHomeRun QuickTV app. All channels changes are quick. No LED's blink with channel changes when using the QuickTV app. Nor do LED's blink when QuickTV quits/released the tuner.</p><p></p><p>Logs attached...</p></blockquote><p></p>
[QUOTE="T^2, post: 1058086, member: 145022"] So... Still getting some odd behavior even with the firewall turned off. Most of the time the channel changes are quick in MP. However, occasionally the channel change can take an excessive amount of time. Say Tuner 0 is currently active, command a new channel, and it just waits. While waiting Tuner 1 LED will start blinking and will remain blinking for some time after the channel change finally happens (eventually going out). Tuner 0's LED remains steady the whole time. I noted the following from SD's installation instructions: Also note that there are no channel changing issues with the HDHomeRun QuickTV app. All channels changes are quick. No LED's blink with channel changes when using the QuickTV app. Nor do LED's blink when QuickTV quits/released the tuner. Logs attached... [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
MediaPortal 1
Support
Watch / Listen Media
Television (MyTV frontend and TV-Server)
MP 1.6 and HDHomerun Prime - not releasing / deactivating tuners when done.
Contact us
RSS
Top
Bottom
