New Ambient Lighting system - no knowledge (4 Viewers)

The_Stig

Retired Team Member
  • Premium Supporter
  • April 5, 2005
    2,176
    428
    Can you try it with different rates in config like:

    "rate" : 500000

    "rate" : 750000

    "rate" : 900000
    Will do.
    Bug in installer I think as it should just replace it, best to run this command before the wget one:

    sudo rm /etc/hyperion.config.json
    Done already and "old" hyperiond is now running since 48 minutes with ~12% CPU load. No increase so far.
     

    The_Stig

    Retired Team Member
  • Premium Supporter
  • April 5, 2005
    2,176
    428
    Looks good so far...2,5hours yesterday evening without problem...pressing the thumbs here
     

    The_Stig

    Retired Team Member
  • Premium Supporter
  • April 5, 2005
    2,176
    428
    So, working quite good now. I am happy! One question remaining: every once in a while when HTPC is turned off, I have a single LED flashing shortly (either its the first or the last LED). Is this supposed to be?
     

    Rick164

    MP Donator
  • Premium Supporter
  • January 7, 2006
    1,335
    1,005
    Home Country
    Netherlands Netherlands
    I have this sometimes when putting mine to sleep as well (bottom right side short one time flash), think it's an Hyperion thing as I tried with resistor / elco (for safety + consistent power) but had the same results.
     

    Lightning303

    MP Donator
  • Premium Supporter
  • September 12, 2009
    798
    577
    Home Country
    Germany Germany
    Soooooo, i am using an arduino and AtmoWin, and i have the same thing :p. When waking up or going to sleep the last (or first) led blinks once (in blue).
     

    The_Stig

    Retired Team Member
  • Premium Supporter
  • April 5, 2005
    2,176
    428
    Ok, first problems: fast flickering hugely over the screen, especially on brighter colours. This is with MP-Plugin and hyperion remote too (e.g. rainbow swirl). Power issue? What do you think
     

    The_Stig

    Retired Team Member
  • Premium Supporter
  • April 5, 2005
    2,176
    428
    Damnit. After flickering and trying the latest build from hyperion I now have static weird colours. Nothing happening...:cry::cry::cry:

    Ok, this one was mine. Didn't update the hyperion.config.json. Now only flickering again. This is on bottom and right side only on bright coulours. I did a power connection only to front and last strip. Maybe a loose connection then on last strip?
     
    Last edited:

    The_Stig

    Retired Team Member
  • Premium Supporter
  • April 5, 2005
    2,176
    428
    Ok, working again. Checked all cables...they looked fine. After this check, LEDs working again. So I guess a loose contact or anything similar...
     

    Users who are viewing this thread

    Top Bottom