Scanning DVB-C Results In 0 Channels & No Signal (1 Viewer)

[EViS]

TV-Server Version: 1.0 RC1 SVN 19010
MediaPortal Version: 1.0 RC1
MediaPortal Skin: Blue Wide
Windows Version: Windows XP SP2
CPU Type: Intel Core 2 Duo e6600
HDD: 1863.02 GB
Memory: 2 GB
Motherboard: Asus P5B
Video Card: ATI Radeon X1900XT
Video Card Driver:
Sound Card: M-Audio Rev. 5.1
Sound Card AC3: Coax Out
Sound Card Driver:
1. TV Card: Technotrend C-1500
1. TV Card Type: DVB-C
1. TV Card Driver: 4.4.10.18
Remote: USBUIRT IR Receiver
TV - HTPC Connection: DVI

Trying to scan DVB-C (UK) results in no channels. The entire scan takes about 5 seconds as well and each transponder reports "No Signal"... Anyone have any suggestions?

 

[EViS]

Unfortunately the following is out of my depth, however a possible solution or aid to one:

Error message: "Attempted to read or write protected memory."

 

[EViS]

MPTestTool logs now also attached. Any dev's (or users) have the same problem?

 

[k15ke90]

I have exact same issue...

TV-Server Version:
MediaPortal Version: RC2
MediaPortal Skin: Blue Two Wide
Windows Version: Windows XP SP3
CPU Type: Intel Core 2 Duo E4500 2,2 GHz
HDD: Samsung 500 GB
Memory: 3 GB XMS2
Motherboard: ASUS P5E-VM HDMI
Video Card: Intel G35
Video Card Driver:
Sound Card: Intel HDMI Sound
Sound Card AC3:
Sound Card Driver:
1. TV Card: Floppy DTV C/CI
1. TV Card Type: DVB-C
1. TV Card Driver: 4.5.0
2. TV Card:
2. TV Card Type:
2. TV Card Driver:
3. TV Card:
3. TV Card Type:
3. TV Card Driver:
4. TV Card:
4. TV Card Type:
4. TV Card Driver:
MPEG2 Video Codec: MPV
MPEG2 Audio Codec: MPA
h.264 Video Codec: CoreAVC
Satelite/CableTV Provider: YouSee (former TDC)
HTPC Case: Antec Minuet 350
Cooling:
Power Supply:
Remote: MCE
TV: Samsung LE32M86
TV - HTPC Connection: HDMI

Trying to re-install to get RC2 I have the same issue. Re-installd (now using MySQL) and no channels get listed when I scan. Sometimes I even get "Card locked" message. FireDTV Viewer can view all channels without any problems....

Now I have NO TV reception ...

Plz help!

 

[vvulture]

Same here.. updated to RC2 and now no signal when scanning for channels... :-(

EDIT - Went back to RC1 SVN 19453 and it all works again..

EDIT 2 - Sorry.. should be more specific.
Running RC1 TVServer on WHS.
After updating to RC2, could no longer scan channels. Just says 'NO SIGNAL".
Reverted back to RC1 and all is working again..

 

[4irm]

same here - analog tv works flawlessly on RC2 - dvb doesnt at all. pretty annoying!!!!!!!! (RC1 was ok)