Reply to thread

Message

<blockquote data-quote="RonD" data-source="post: 1085937" data-attributes="member: 117536">Jovan,I downloaded your tvguide.xml file and see the same problem. Channels that have ( ) in the channel name are seen when you try to map them with the xmltv mapping but do not save/load correctly. For exampleWTVJ worksWarner Channel (Venezuela) failsI used notepad++ to edit tvguide.xml, did a global find/replace (Venezuela) with [Venezuela], the file saves/loads correctly MePo xmltv and the tvguide.xml file imports for channels with the () replaced with [].attached is my new tvguide.com.ini file. I emailed this to the WG++ dudes but it is not in the official released version. It fixes the way channels are generated and you will need to generate a new channel file. Hopefully this will show up in the WG++ site in the next few days.<a href="http://webgrabplus.com/forum" target="_blank">http://webgrabplus.com/forum</a>You can also modify the channel generation code by adding the following 3 lines in red at the end of the channel generation code just before end_scope.index_site_id.modify {cleanup(removeduplicates=equal,100 link=&quot;index_site_channel&quot;)}* replace ( ) in channels with [ ]index_site_channel.modify {replace|)|]}index_site_channel.modify {replace|(|[}end_scope[USER=82144]@mm1352000[/USER] or somebody else with source code, are there known &quot;reserved&quot; symbols for channel names? I also saw this problem when I was using WG++ generated channel names. If I hack the channel names to remove () or replace () with [] and MePo xmltv code can use the WG++ generated names.I renamed the tvguide.com.ini file tvguide.com.txt so I could upload it to the forum.</blockquote>

[QUOTE="RonD, post: 1085937, member: 117536"] Jovan, I downloaded your tvguide.xml file and see the same problem. Channels that have ( ) in the channel name are seen when you try to map them with the xmltv mapping but do not save/load correctly. For example WTVJ works Warner Channel (Venezuela) fails I used notepad++ to edit tvguide.xml, did a global find/replace (Venezuela) with [Venezuela], the file saves/loads correctly MePo xmltv and the tvguide.xml file imports for channels with the () replaced with []. attached is my new tvguide.com.ini file. I emailed this to the WG++ dudes but it is not in the official released version. It fixes the way channels are generated and you will need to generate a new channel file. Hopefully this will show up in the WG++ site in the next few days. [url]http://webgrabplus.com/forum[/url] You can also modify the channel generation code by adding the following 3 lines in red at the end of the channel generation code just before end_scope. index_site_id.modify {cleanup(removeduplicates=equal,100 link="index_site_channel")} [COLOR=#ff0000]* replace ( ) in channels with [ ] index_site_channel.modify {replace|)|]} index_site_channel.modify {replace|(|[}[/COLOR] end_scope [USER=82144]@mm1352000[/USER] or somebody else with source code, are there known "reserved" symbols for channel names? I also saw this problem when I was using WG++ generated channel names. If I hack the channel names to remove () or replace () with [] and MePo xmltv code can use the WG++ generated names. I renamed the tvguide.com.ini file tvguide.com.txt so I could upload it to the forum. [/QUOTE]

Verification