Reply to thread

Message

<blockquote data-quote="Trciky1024" data-source="post: 1157969" data-attributes="member: 134458">Johanj / ShukuyenI can see looking at wifiremote beta release code you have hard coded the connection to the Pioneer AMP and then setup control. as you are looking to expand this control would it be possible add eventghost as a hardware plugin?Now my thoughts are this. EG support plugins for most receivers now, so EG can control my Pioneer over IP if I wanted.I have tested the connection works to EG if we have the web browser plugin installed, so when you install you setup a port (i.e. 1234), Event Prefix (i.e. HTTP) and authentication if required. we can then issue local events to the browser.i.e.<a href="http://127.0.0.1:1234?WIFIremote.volup" target="_blank">127.0.0.1:1234?WIFIremote.volup</a>&nbsp;&nbsp; -&gt; triggers event WIFIremote.volup in EG.We can have events for volup, vol down, mute and any other events that we need to home automation.We would need to configure the following fields within the hardware section:ipaddress of EG machine (default to 127.0.0.1)port used by webserver (default to 1234)</blockquote>

[QUOTE="Trciky1024, post: 1157969, member: 134458"] Johanj / Shukuyen I can see looking at wifiremote beta release code you have hard coded the connection to the Pioneer AMP and then setup control. as you are looking to expand this control would it be possible add eventghost as a hardware plugin? Now my thoughts are this. EG support plugins for most receivers now, so EG can control my Pioneer over IP if I wanted. I have tested the connection works to EG if we have the web browser plugin installed, so when you install you setup a port (i.e. 1234), Event Prefix (i.e. HTTP) and authentication if required. we can then issue local events to the browser. i.e. [URL='http://127.0.0.1:1234?WIFIremote.volup']127.0.0.1:1234?WIFIremote.volup[/URL] -> triggers event WIFIremote.volup in EG. We can have events for volup, vol down, mute and any other events that we need to home automation. We would need to configure the following fields within the hardware section: ipaddress of EG machine (default to 127.0.0.1) port used by webserver (default to 1234) [/QUOTE]

Verification