Reply to thread

Message

<blockquote data-quote="GizTVNewbie" data-source="post: 354444" data-attributes="member: 48789">After a while......I figured out how the whole stuff may work for me.However WebEPG is not that fun. Many times it works not correctly or the program guide itself is corrupted or the WebEPGGrabber does not get any information at all. At the moment I run the WebEPG manually.I really hope that thinks will get right with the DVB-EPG grabber, which I will test later on.I did some additional tests. First I ran a KNC-ONE DVB-C card with KNC-BDA drivers. I downloaded the latest version from the KNC site. I did that just for testing purposes. All programms were found and all works, beside the DVB-EPG and the hanging tv server.In the past (MP 1.0 RC1) I ran Terratec Cinergy 1200 drivers, version 4.8.17 with my KNC-ONE DVB-C. Thus I decided to move to these drivers again (and they are also recommended by MP I think). I downloaded Terratec Cinergy 1200 4.8.18 (the lastest) and made a re-scan. all worked perfectly and no more hanging tv server. But the signal quality was not that good, I had some &quot;holes&quot; when receiving the tv program. So I decided to move back to Terratec Cinergy 1200 4.8.17. All works now as expected. All I have to check is if the DVB-EPG grabber still causes conflicts. I will tell here ASAP...GizTVNewbie</blockquote>

[QUOTE="GizTVNewbie, post: 354444, member: 48789"] [b]After a while...[/b] ...I figured out how the whole stuff may work for me. However WebEPG is not that fun. Many times it works not correctly or the program guide itself is corrupted or the WebEPGGrabber does not get any information at all. At the moment I run the WebEPG manually. I really hope that thinks will get right with the DVB-EPG grabber, which I will test later on. I did some additional tests. First I ran a KNC-ONE DVB-C card with KNC-BDA drivers. I downloaded the latest version from the KNC site. I did that just for testing purposes. All programms were found and all works, beside the DVB-EPG and the hanging tv server. In the past (MP 1.0 RC1) I ran Terratec Cinergy 1200 drivers, version 4.8.17 with my KNC-ONE DVB-C. Thus I decided to move to these drivers again (and they are also recommended by MP I think). I downloaded Terratec Cinergy 1200 4.8.18 (the lastest) and made a re-scan. all worked perfectly and no more hanging tv server. But the signal quality was not that good, I had some "holes" when receiving the tv program. So I decided to move back to Terratec Cinergy 1200 4.8.17. All works now as expected. All I have to check is if the DVB-EPG grabber still causes conflicts. I will tell here ASAP... GizTVNewbie [/QUOTE]

Verification