Reply to thread

Message

<blockquote data-quote="mm1352000" data-source="post: 1153649" data-attributes="member: 82144">Next step is to configure or learn the IR commands.Try to find the vendor/model of your STB in the quick setup field. If you can find it, select it and click &quot;set.If not, you will need to learn the commands for 0, 1, 2, 3, 4, 5, 6, 7, 8 and 9 back in the main part of the TV3 Blaster plugin -&gt; IR Commands tab. When you learn the commands, make sure you hold the remote very close (1 inch or so) to the USB-UIRT's receiver. Also make sure to select the correct port to blast with. You can probably blast with both ports, but technically it is probably better/faster to only select the 1 port (port 1 or port 2) that you're actually going to use. If your STB requires you to press &quot;4&quot; + &quot;2&quot; + &quot;select/OK/enter&quot; (or changes channel faster when you do that) then you probably also want to learn the &quot;select/OK/enter&quot; command too. After learning, go back into the STB setup (remember to select the correct tab for your tuner!) and assign the commands for &quot;Digit 0&quot; through &quot;Digit 9&quot; (and optionally: &quot;select&quot;). You assign a command by selecting the command row, selecting the corresponding command in the drop-down list below the commands, then clicking &quot;set&quot;.I cannot tell you what values to use for the settings on the right hand side. You will need to use common sense + trial/error to work them out. I would be quite surprised if the defaults are not okay.After doing all this, use the &quot;test&quot; function in the bottom right hand corner to test that the blaster is working. We cannot proceed until the blaster is working.</blockquote>

[QUOTE="mm1352000, post: 1153649, member: 82144"] Next step is to configure or learn the IR commands. Try to find the vendor/model of your STB in the quick setup field. If you can find it, select it and click "set. If not, you will need to learn the commands for 0, 1, 2, 3, 4, 5, 6, 7, 8 and 9 back in the main part of the TV3 Blaster plugin -> IR Commands tab. When you learn the commands, make sure you hold the remote very close (1 inch or so) to the USB-UIRT's receiver. Also make sure to select the correct port to blast with. You can probably blast with both ports, but technically it is probably better/faster to only select the 1 port (port 1 or port 2) that you're actually going to use. If your STB requires you to press "4" + "2" + "select/OK/enter" (or changes channel faster when you do that) then you probably also want to learn the "select/OK/enter" command too. After learning, go back into the STB setup (remember to select the correct tab for your tuner!) and assign the commands for "Digit 0" through "Digit 9" (and optionally: "select"). You assign a command by selecting the command row, selecting the corresponding command in the drop-down list below the commands, then clicking "set". I cannot tell you what values to use for the settings on the right hand side. You will need to use common sense + trial/error to work them out. I would be quite surprised if the defaults are not okay. After doing all this, use the "test" function in the bottom right hand corner to test that the blaster is working. We cannot proceed until the blaster is working. [/QUOTE]

Verification