Wrong name displayed in Manual Control (1 Viewer)

[vuego]

TV-Server Version: SVN 16036
MediaPortal Version: 0.2.3.0 RC1 SVN 16039
Windows Version: Vista Ultimate x86
1. TV Card: Terratec Cinergy 1200
1. TV Card Type: DVB-C
1. TV Card Driver:
2. TV Card: Hauppauge PVR350
2. TV Card Type: analog
2. TV Card Driver:

In Manual Control of TV Server setup, the name of the channel currently being recorded or timeshifted, is displayed. However for analog channels it is not the Name that is displayed but the Channel information of the Analog tab.

 

[kuehnch]

In my mind, this is a correct behaviour.
Since a few revisions, there is a "name"- and a "displayName"-field in the channel-databasetable. The name-field holds the channelname as it was found while the channelscan. This identifier is used internally to map epg-data correctly. The displayName-field contains the channel-identifier that you typed in manually or that was set dynamically (some digital-tv-channels have dynamic channelnames).

For a better debugging/error-troubleshooting, the status-screen shows up the "name" instead of the "displayName".

My suggestion: The status-screen (manual-control) should show up both names.