Ran into this problem following an otherwise sucessful upgrade from MP 1.34 x64 to MP 1.35 x64 the CEC Remote plugin which I use just to control volume and standby, will no longer put my devices (TV & AVR) to sleep when the HTPC is put in standby. Also when I wake up the HTPC MP closes or crashes (not sure which) as per the example in...
Ran into this problem following an otherwise sucessful upgrade from MP 1.34 x64 to MP 1.35 x64 the CEC Remote plugin which I use...
Ran into this problem following an otherwise sucessful upgrade from MP 1.34 x64 to MP 1.35 x64 the CEC Remote plugin which I use...
When my AVR bit the dust recently I took the opportunity to upgrade my projector to an LS11000 to gain 4K. Install went fine until I switched to my HTPC which is my primary source. When I switch to the HTPC the screen goes blank for a long time and then I have sound, no picture, and in the lower left hand corner:
"Source: HDMI 1
Not...
When my AVR bit the dust recently I took the opportunity to upgrade my projector to an LS11000 to gain 4K. Install went fine until...
When my AVR bit the dust recently I took the opportunity to upgrade my projector to an LS11000 to gain 4K. Install went fine until...
Ok, so perhaps a solution, but not the "right" solution. On the client, within media portal configuration, under TV settings, advanced options, I switched to UNC paths instead of the default RSS, and it's working very well. Sure I had to figure out the paths, but no big deal.
Maybe helpful for someone in the future. Thanks for the...
Ok, so perhaps a solution, but not the "right" solution. On the client, within media portal configuration, under TV settings...
Hi folks. I have an issue with a new install/integration into my mediaportal system. I have a “mediaportal server” which has the TV...