MediaPortal Version: MediaPortal-svn--10-24-2006--19-59-Rev11306
TV Engine: tvengine3-10-24-2006--15-18h--Rev11304
1. TV Card: Hauppauge PVR350
1. TV Card Type: Analog h/w
1. TV Card Driver: 1.18.21.22266 / 22-9-2004
My PVR350 seems to be working quite OK with the new tv engine setup. (DVB-T FloppyDTV is another story and another post).
But the old issue of fine tuning with certain channels in The Netherlands (and other countries probably too) seems to be back: I only seem to be able to (auto)tune by channel.
I set it on county 'The Netherlands', 'Antenna' and then to tune. I also tried this with the setting on 'Cable', and both on Medium and High sensitivity.
It finds almost all channels nicely, but that are the channels that are right on a proper cable-channel. But certain channels are on channels like '51-' and '62+'. Those require finetuning, and in WinTV2000 and the old tv engine the way to do this is by specifying the frequency of the channel.
This option seems to be nowhere in the tv engine setup dialog.
I also tried with the SQL Manager utility to dive into the TuneDetail table and specify a frequency for the channel there (tried both Hz and Khz) and create a channel from scratch (some where not found).
Is it possible to specify manual analog frequencies? If so, what am I doing wrong? If not, could this please be added.
TV Engine: tvengine3-10-24-2006--15-18h--Rev11304
1. TV Card: Hauppauge PVR350
1. TV Card Type: Analog h/w
1. TV Card Driver: 1.18.21.22266 / 22-9-2004
My PVR350 seems to be working quite OK with the new tv engine setup. (DVB-T FloppyDTV is another story and another post).
But the old issue of fine tuning with certain channels in The Netherlands (and other countries probably too) seems to be back: I only seem to be able to (auto)tune by channel.
I set it on county 'The Netherlands', 'Antenna' and then to tune. I also tried this with the setting on 'Cable', and both on Medium and High sensitivity.
It finds almost all channels nicely, but that are the channels that are right on a proper cable-channel. But certain channels are on channels like '51-' and '62+'. Those require finetuning, and in WinTV2000 and the old tv engine the way to do this is by specifying the frequency of the channel.
This option seems to be nowhere in the tv engine setup dialog.
I also tried with the SQL Manager utility to dive into the TuneDetail table and specify a frequency for the channel there (tried both Hz and Khz) and create a channel from scratch (some where not found).
Is it possible to specify manual analog frequencies? If so, what am I doing wrong? If not, could this please be added.