[WiP] madVR support in MP1 (16 Viewers)

[Sebastiii]

And V5 to compare against V4

 

[daWooky]

ya to fast
used mad settings (lav cb)and little log from v4 on htpc2. all good exept fse with tv

 

[daWooky]

v5 also had some fse problem and just crashed

[2017-11-21 21:58:25,799] [Log    ] [MPMain   ] [ERROR] - Exception: Fehler in der Anwendung.
-2147467259 (E_FAIL)
   bei Microsoft.DirectX.Direct3D.Device.PresentInternal(tagRECT* sourceRectangle, tagRECT* destRectangle, IntPtr overrideWindow)
   bei Microsoft.DirectX.Direct3D.Device.Present()
   bei MediaPortalApp.Render(Single timePassed)  Message: Fehler in der Anwendung.  Site   : Void PresentInternal(Microsoft.DirectX.PrivateImplementationDetails.tagRECT*, Microsoft.DirectX.PrivateImplementationDetails.tagRECT*, IntPtr)  Source : Microsoft.DirectX.Direct3D  Stack Trace:     bei Microsoft.DirectX.Direct3D.Device.PresentInternal(tagRECT* sourceRectangle, tagRECT* destRectangle, IntPtr overrideWindow)
   bei Microsoft.DirectX.Direct3D.Device.Present()
   bei MediaPortalApp.Render(Single timePassed)

 

[Sebastiii]

Ok will try to try FSE
FSE often crash my PC (Green screen) so hard to debug.

So FSE didn't works on start and it failed also on stop right ?

 

[daWooky]

right and on quick usage

Gesendet von meinem Nexus 7 mit Tapatalk

 

[Sebastiii]

I did try 10 FSE start on ratatouille (no 3D) and 2 starts for 3D MVC (mkv) with FSE DX9 on HTPC all start and stop correctly, but it's on 1703 lol.
I will try with your settings to compare

 

[Sebastiii]

Ok tested with your settings as above and no crash and FSE was working ok so hard to tell

On 1703, i didn't use : (Disable fullscreen ....)

Ah need to test with DXVA-CB but like this mode didn't work for USD, i did use native lol

 

[Sebastiii]

Ok same with DXVA2-CB, works pretty good on HTPC and each start of 3D MVC runs correctly so no real clue

 

[Sebastiii]

But i didn't test the TV part so will try before going to bed ahah

 

[daWooky]

hehe.thanks
will try with 1703 tomorrow and compare...