MediaPortal 2 Version: 2.1.3
Description
As first reported in this thread.
I seem to have a bug where if I use the MP2 client while a recording is active, the resultant recording is shortened.
In all these tests, the programme was 60 minutes long, with a 5 minute lead-in and a 15 minute lead-out (80 minutes total).
Tests 1 & 2
I scheduled two recordings to occur when I was at work, so the PC would not be disturbed.
Both these recordings were completely successful.
Test 3
I scheduled this recording to begin while the client was off. The recording started at 6:55 PM and was set to run until 08:15. At approximately 7:30 I launched the client and watched part of the programme as it was recording.
The recording shows that is started at 7:33 PM (presumably when I launched the client). The run time is 42 minutes, the difference between 7:33 PM and 8:15 PM
Tests 1 & 2 prove that the recoding would have been started at the correct time, but somehow launching the client has cut off the start of the recording.
Steps to Reproduce:
1) Schedule a recording.
2) While the recording is active, launch the MP2 client
Note: I am not sure exactly what caused the recoding to corrupt, but I mostly tried watching TV including the programme that was recoding. When I launched the client I got the message "Recording has started".
Description
As first reported in this thread.
I seem to have a bug where if I use the MP2 client while a recording is active, the resultant recording is shortened.
In all these tests, the programme was 60 minutes long, with a 5 minute lead-in and a 15 minute lead-out (80 minutes total).
Tests 1 & 2
I scheduled two recordings to occur when I was at work, so the PC would not be disturbed.
Both these recordings were completely successful.
Test 3
I scheduled this recording to begin while the client was off. The recording started at 6:55 PM and was set to run until 08:15. At approximately 7:30 I launched the client and watched part of the programme as it was recording.
The recording shows that is started at 7:33 PM (presumably when I launched the client). The run time is 42 minutes, the difference between 7:33 PM and 8:15 PM
Tests 1 & 2 prove that the recoding would have been started at the correct time, but somehow launching the client has cut off the start of the recording.
Steps to Reproduce:
1) Schedule a recording.
2) While the recording is active, launch the MP2 client
Note: I am not sure exactly what caused the recoding to corrupt, but I mostly tried watching TV including the programme that was recoding. When I launched the client I got the message "Recording has started".
Last edited: