New Zealand
Is this just my settings or is this not supported yet. I have saf4 unlocked all recommended settings and no luck.
Thanks In advance
Thanks In advance
Unable to play video codec: XVID and Audio Codec: MPEG Audio (1 Viewer)
- Thread starter Quarter
- Start date
Users who are viewing this thread
Similar threads
DOH.....another senior moment for me, as I've been here before some years ago!
Thanks again :)
DOH.....another senior moment for me, as I've been here before some years ago!
Thanks again :)
After some time working seamlessly....have run into a brick wall with this!
Have tried switching from MadVr to EVR....and problem...
I compliment you on the thoroughness of your investigations. (y)
Unfortunately, I don't have any ideas what the problem might be. :(
Perhaps someone else will post with some suggestions. :unsure:
-- from CyberSimian in the UK
I compliment you on the thoroughness of your investigations. (y)
Unfortunately, I don't have any ideas what the problem might be...
Would appreciate it if someone could solve (or point me in the right direction to resolve) this issue.
I have “MultiSeat”...
You can find ton of guide here:
https://www.avsforum.com/threads/madvr-player-support-thread.2215490/?post_id=39123050#post-39123050
You can find ton of guide here:
https://www.avsforum.com/threads/madvr-player-support-thread.2215490/?post_id=39123050#post-39123050
Hi,
I have a problem if I set madVR as Video Render. When I try to play my .mkv files I have an 'Unable to play. Video COdec...
MP1
MP2
MP2 - V2.3
Difference between using specific audio renderer versus "Default WaveOut Device"?
DE
Sorry, it's my fault -- I did not notice that you are using MP2. :(
MP1 has a separate configuration utility, similar to "TV Server Config". I have tried MP2 only a couple of times, and have never used it seriously. I don't know what MP2 supports with regard to adjusting audio delay, but I do know that all of the adjustments of...
Sorry, it's my fault -- I did not notice that you are using MP2. :(
MP1 has a separate configuration utility, similar to "TV...
Hi. I recently upgraded my home cinema AVR which also meant changed from sending audio from my HTPC as 5.1 using optical to 7.1...
.....it was also the culprit for me!!! Can't think why I've changed from LAVsplitter to MPurl ......:oops:
Videos playing now.....so thanks!
.....it was also the culprit for me!!! Can't think why I've changed from LAVsplitter to MPurl ......:oops:
Videos playing...
Just upgraded to 1.37 'Willow'.....and although TV is fine.....I'm unable to play video.
Error message points to Mpeg4IsoAvc or...