WInTV-HRV950Q WIndows 10 (1 Viewer)

[luv2spooge]

Hello,

I have a WinTV-HRV tv tuner, but I can't watch live tv. I try scanning for channels with QAM in every option they had but every time it says "no signal" Just wonder if anyone has some advice for me.

 

[mm1352000]

Hello and welcome

Are you sure you're scanning with the right tuning mode setting?
http://wiki.team-mediaportal.com/1_...ration/02_TV_Servers/7b_Scan_ATSC#Tuning_mode

 

[luv2spooge]

if you can help me out, which settings should I Apply with my Happauge WinTV-HVR 950Q tv tuner.. I installed all the drivers needed for my device

 

[mm1352000]

if you can help me out, which settings should I Apply with my Happauge WinTV-HVR 950Q tv tuner.

I can't tell you because I don't know how you receive TV (cable, antenna etc.). However I gave you a link to the relevant section of the wiki (manual). If you read that, you should be able to figure out which settings to use. That's the best we can do until/unless you choose to share more information.

 

[luv2spooge]

Thanks..I have Analog cable with a digital convertible box. I connected the cable box with my tv tuner and installed all the drivers I needed. On the Tv server configuration I'm connected through what looks like my ip address. when I check the settings there I come across my device which is my WinTV tuner. The two options are Analog WinTV, and ATSC WinTV. When I chose either option and try to scan with QAM Frequencies I get "no signal" and that's when I try scanning all the frequencies

 

[mm1352000]

I have Analog cable with a digital convertible box.

Are you sure it isn't the other way around - digital cable with an analog converter box?

I connected the cable box with my tv tuner...

How did you do this?
Is the connection:

• RF/coax
• RCA/phono/cinch
• s-video
• other (please describe)

On the Tv server configuration I'm connected through what looks like my ip address. when I check the settings there I come across my device which is my WinTV tuner. The two options are Analog WinTV, and ATSC WinTV.

Yes, that's normal.

When I chose either option and try to scan with QAM Frequencies I get "no signal" and that's when I try scanning all the frequencies

I understand. It seems obvious that "clear QAM cable" is probably not the right scanning option for you to be using. I need answers to the questions above before I can tell you which options are the right ones.