Recent content by ARE2

Hej, if this could be realized, that would be awesome :) Regards

Hi, just checked it and unfortunately not. I just see the bare Timeline in the Info OSD. The screenshot attached shows a state, where I already used timeshift (-1min) and as you can see, no visual informations about that at all. I don't even see, with this kind of progress bar, where I'm in...

Oh, ok. I see. I'm not using IPTV so can't tell anything about it, but I use LiveTV and with that Timeshift is working flawless :) Nevertheless, big Thanks for asking :)

Oh, ok. I see. I'm not using IPTV so can't tell anything about it, but I use LiveTV and with that Timeshift is working flawless :)

Hi, actually I' looking for something like on the attached Screenshot (MP1 timeshift example). In that case I just pushed the arrow key (left) btn on my remote in MP1. Then I get an OSD with the current time-bar and additonal infos. I think the "info" OSD of MP2 is somehow what I'm looking...

Hello, after round about a decade of using MP1 I decided to test the so far most current version of MP2. Overall I like it very much!!! But what I'm missing a lot is the GUI behaviour, when pushing left or right, that showed up the Timeshift progress bar. That was especially usefull when using...

Hi mm1352000, big THX so far for looking into my Problem. I really appreciate it :) ! Concerning my provider I'll call him again to check if the "Signal" is really beeing sent. If the WinTV-CI is compatible... well hard to tell, but my provider is not using CI+, thats for sure. It's just...

Hi, ok, that's what I did: - Changed waitForTimeshift and waitForUnscrambledSignal in the DB to 360Sec. (just to be really sure). - Restarted the machine - Everything started as usually - Tuned the channel my provider told me (TVP1) - Tuning started and I had nice 360Sec. of black screen. So DB...

Hi, tried that, no success. Even changed the Timeout in the DB but this deosn't seem to work. TV-server just ignores my DB changes and tunes the maximum ammount of time that can be adjusted in the setup.

Hi, no :(

Hi, for my card (smartcard) activation I have to tune a specific channel for 40 Seconds. MP lets me do that for only 15 Seconds until I get the "Channel is scrambled" Info and I 've got no clue how to get my subscription activated with MP this way? My provider says there is no other possibility...

Hi, my solution for that problem: Deactivated power saving options for this device and everything started working flawless :)

Hi, just agin for the record and everyone that stumbles upon the same Probs.: Yes, I couldn't believe it, but the drivers were really not completely installed :( Installing the drivers as suggested by Hauppauge is not enough!!! They don't tell that even after a full and successfull install of...

Hi everybody, I have a very strange Problem: Reinstalled Win7 with all Win-Updates available till now. Then installed the latest Win-TV Hauppauge Drivers for my Card. Restarted the system. Installed WinTV-CI drivers. Restarted the System again. Installed MP 1.7.0, restarted the system once...

FTR: Reinstalled Win7 with all Win-Updates available till now. Then installed the latest Win-TV Hauppauge Drivers for the Card. Restarted the system. Installed WinTV-Ci drivers. Restarted the System again. Installed MP 1.7.0, restarted the system once again. Opened the TV-Server Config and...