Recent content by Marcus Venturi

I tested 3D and it works with my projector even if the setting is unticked, but NVIDIA and 3D is sometimes not very reliable, will do some further checks... And later when I wanted to look TV the TV asked me to turn 3D on, looks like it makes sense to switch back to the old refresh rate when the...

Wow, that solves it (y) I ticked this setting as I watch a lot of 3D movies and thought it was necessary for that. The question is if 3D movies still work when this is unticked...will test that later...

In my case it happens on my Desktop as well as on my HTPC, not matter if I resume a movie or start from the begin...

I think you mean 'switch to matching display mode..."? I turned it off, but behavior stays the same...

Refreh rate stuff in MePo is off: MadVR settings: Delay Playback start until render queue is full is set to on: I already played with DIrect3D 9/11 switches in madVR and FSE/windowed, but no success yet...

Hi Sebastiii, the integration of madVR in MePo is really fantastic (y). I started to play with it and everything works pretty good, but I have the problem at start of a movie. Everytime when I start a movie it stops immediatelly and I have to press play again, then it works. This happens from...

Thank you for the info (y), so I have to wait. Yes they take really long to resolve their problems after switching to V3. Looks like they didn't spend not too much time in testing before switching to V3, as the most bugs are really obvious :(...

Have found a problem concerning season artwork. Just did a test with the Series "Limitless". A good test case, as it has only one season (very sad that they have discontinnued it :(), The poster/banner for the series get imported, but the season remains emtpy... Any clue what's going wrong?

Something has happened! :) As my mainboard uses a Realtek chipset for network I often checked their homepage for new Drivers the last months. So I did yesterday and found a new driver published on 2016/12/27 (3 days before). I installed the new driver and now the situation really got better...

OK after switching from RTSP to UNC there is on difference. With RTSP I had sound and the picture started after 30 seconds. Now with UNC I have nothing. The sound appears after 15 seconds and the picture after 30 seconds from the first tune after resume. I don't know if that hint helps. This...

OK, I switched from RTSP to UNC, but the same result. The sound and the video are from the same source. So if there is a problem with the network, I would have assumed, that both is delayed.

In most of my other logs I was using the option 1 of the Watchdog tool. As the error also happened then, I assume it's not a 3rd party tool, as that option disables 3rd Party plugins. Is that correct? Thank you for the reminder to the UNC stuff. I forgot to check that. Will do this ASAP.

I turned off PowerScheduler. I checked that IPV6 is definitely off on server and client. I completely turned off Windows Defender on the client. The delay was a bit shorter this morning, but it's still there.The Problem only happens if the client is off for a few hours (not minutes).

Yes I used option 1. Will try disabling PowerScheduler. Maybe I should change power state settings in the BIOS.

Resumed the HTPC this morning and waited 5 minutes on the desktop before starting TV. Delay is still there. What is also very strange: If I suspend the PC then and resume immediately, everything works fine. Only if the PC was suspended for a longer time the delay occurs.