After Channel scan -> Preview failed:Unknown Error (1 Viewer)
- Thread starter MaxMan23
- Start date
Germany
Users who are viewing this thread
Similar threads
I switched back to MePo 1 some time ago, and havent really used it that much.
But i wanted to watch some old movies stored as ISO file.
Virtuel Clone drive is installed, and it can mount the ISO file.
However when i try to select it from MePo i only get an error that i cannot mount it.
[2026-06-07 14:56:35,994] [Error ] [MPMain ]...
I switched back to MePo 1 some time ago, and havent really used it that much.
But i wanted to watch some old movies stored as ISO...
I switched back to MePo 1 some time ago, and havent really used it that much.
But i wanted to watch some old movies stored as ISO...
Thank you for confirming that U&W works for you.
I ended up deleting U&W and rescanning for channels. That fixed the issue.
Thank you for confirming that U&W works for you.
I ended up deleting U&W and rescanning for channels. That fixed the issue.
I have setup Refresh DVB EPG so that BBC One is the grabber channel (which is meant to grab all available channels) but the U&W...
As Alexander Pope said:
A little learning is a dangerous thing,
and Dr Google explains this as:
The quotation warns that superficial knowledge of a subject can make people arrogant or foolish, suggesting one should either learn deeply or not at all.
"Superficial", and "arrogant or foolish" would be me :eek: . However...
I would...
As Alexander Pope said:
A little learning is a dangerous thing,
and Dr Google explains this as:
The quotation warns that...
I have just discovered that I can no longer receive any of the independent radio channels broadcast on DVB-T in the UK. In...
I note that you are using MP2. The following applies to MP1, but I think that MP2 is identical in this situation.
"TV Server Config" has a "TV Mapping" panel in the "TV Channels" section. On the "TV Mapping" tab:
The left column lists the channels that have not yet been mapped to the TV tuner identified by the drop-down menu just...
I note that you are using MP2. The following applies to MP1, but I think that MP2 is identical in this situation.
"TV Server...
I've scanned for channels, and got all channels mapped to tuner 0 of my 8 channel TV card (eg: 2 cards of 4 channels each)
Is there...
I meant use MP client to try to spot how it's requesting streams for specific channels and then try to do the same with VLC.
TV Server development looks dead so I'm afraid you're going to have to figure that out by yourself if it's even possible.
I meant use MP client to try to spot how it's requesting streams for specific channels and then try to do the same with VLC.
TV...
Hi everyone,
I've set up Mediaportal TV Server on a Windows 11 box, tuner deteced okay, scanned channels, can preview, all seems...
