Thank you I did not think about that one. The installation goes well. However in configuration I am stuck at the password for SQL database. It used to be sa/sa if I remember correctly. Does someone know the new one? I could not find it in wiki.
Hum I am gona give a try to MediaPortal as password.
Ok, so perhaps a solution, but not the "right" solution. On the client, within media portal configuration, under TV settings, advanced options, I switched to UNC paths instead of the default RSS, and it's working very well. Sure I had to figure out the paths, but no big deal.
Maybe helpful for someone in the future. Thanks for the...
Ok, so perhaps a solution, but not the "right" solution. On the client, within media portal configuration, under TV settings...
Hi folks. I have an issue with a new install/integration into my mediaportal system. I have a “mediaportal server” which has the TV...
I was installing/upgrading x64 over x86.
These 2 problems did not occur when installing/upgrading x86 over x86.
All is good. Now running 1.35 x86 with no problem.
Thank you
I was installing/upgrading x64 over x86.
These 2 problems did not occur when installing/upgrading x86 over x86.
All is good. Now...
Good day,
Same 2 installation problem as last version.
2 problems after upgrading to 1.35 from 1.34:
1- To avoid error message...
We have just released MediaPortal 1.35 - Horizon x86 and x64 version.
Highlights of this release
Bugfixes:
[MP1-5221] - Core: Fix FrameGrabbing for EVR
[MP1-5222] - TV Server: Fix ISO-8859-10/14 DVB text encodings
[MP1-5224] - Fix Card "CancelTune" request
Since Pre-Release :
New:
Since Pre-Release :
Improvement / Rework...
We have just released MediaPortal 1.35 - Horizon x86 and x64 version.
Highlights of this release
Bugfixes:
[MP1-5221] - Core...
We have just released MediaPortal 1.35 - Horizon x86 and x64 version.
Highlights of this release
Bugfixes:
[MP1-5221] - Core...