Hi, Sorry for the previous incorrect postings.
I will start this post for the timeshifting issue and keep the old one for the recording issue.
Today I cleared all logs then rebooted PC. After Startup, i closed MP
Started MP in debug mode to try and replicate error.
First time everything was fine. closed and started debug mode again.
I turned on TV and TV 7 came on.
Changed to TV 1, but instead of getting TV 1 i get a repeat of TV 7 from same point the TV was initially switched on.
I waited a few seconds and then get eventually get TV1 from the point when i changed channel
Changed to TV 2 and then go back to start of timeshift from same point the TV was initially switched on.
Changed to TV 6 and get the same. (all these channels are on same mux)
I then go to TV 3 which is on a different frequency from the others and i get TV3 from live point
Further channel changes all work as expected either on same or different frequency
From the logs it seems to be an issue with MP not tuning in correctly to my tuners
There is no signal problem with these cards despite what the logs seem to say, but even if there were it doesn't explain why the timeshift would loop like it does. I have had no problems with this until RC3.
Here are complete debug logs for the incident described above between 2010-05-22 10:35:12.827000 till end of logs.
cheers
DD
I will start this post for the timeshifting issue and keep the old one for the recording issue.
Today I cleared all logs then rebooted PC. After Startup, i closed MP
Started MP in debug mode to try and replicate error.
First time everything was fine. closed and started debug mode again.
I turned on TV and TV 7 came on.
Changed to TV 1, but instead of getting TV 1 i get a repeat of TV 7 from same point the TV was initially switched on.
I waited a few seconds and then get eventually get TV1 from the point when i changed channel
Changed to TV 2 and then go back to start of timeshift from same point the TV was initially switched on.
Changed to TV 6 and get the same. (all these channels are on same mux)
I then go to TV 3 which is on a different frequency from the others and i get TV3 from live point
Further channel changes all work as expected either on same or different frequency
From the logs it seems to be an issue with MP not tuning in correctly to my tuners
There is no signal problem with these cards despite what the logs seem to say, but even if there were it doesn't explain why the timeshift would loop like it does. I have had no problems with this until RC3.
Here are complete debug logs for the incident described above between 2010-05-22 10:35:12.827000 till end of logs.
cheers
DD