WebEPG not saving my choises (1 Viewer)
- Thread starter stinger82
- Start date
Greece
Users who are viewing this thread
Similar threads
hi team, this error seemed to literally start overnight - not as a result of any windows update or related. tried all the usual things
TVGuide shows no data available in MP2 and after running TVSetup and telling WebEPG to grab now I am presented with the attached error screen -
TvSetup then crashes out.
I have run a repair on...
hi team, this error seemed to literally start overnight - not as a result of any windows update or related. tried all the usual...
hi team, this error seemed to literally start overnight - not as a result of any windows update or related. tried all the usual...
When I tested MP 2.5 some months ago using TVE3.5, I found that "scan for channels" failed to find any channels when I selected a DVB-T2 tuner (a TBS 6284) :(, but succeeded when I used a DVB-T tuner (a Pinnacle 2000i) :). Obviously the Pinnacle found only those channels broadcast in DVB-T MUXes (in the UK we have both DVB-T MUXes and...
When I tested MP 2.5 some months ago using TVE3.5, I found that "scan for channels" failed to find any channels when I selected a...
Hi all
Running 1.7.1.0 TV Server as part of a full upgrade to MP2 2.5 setup
After some problems with retuning (solved -...
That was the correction I made in BasicHome for the 1.35 Prerelease which you adddd to repo ;)
That was the correction I made in BasicHome for the 1.35 Prerelease which you adddd to repo ;)
I'm going bananas here!!
Used MP1 since MP1.10 or so.....an haven't had problems for years!
Am using latest Dune...
When my AVR bit the dust recently I took the opportunity to upgrade my projector to an LS11000 to gain 4K. Install went fine until I switched to my HTPC which is my primary source. When I switch to the HTPC the screen goes blank for a long time and then I have sound, no picture, and in the lower left hand corner:
"Source: HDMI 1
Not...
When my AVR bit the dust recently I took the opportunity to upgrade my projector to an LS11000 to gain 4K. Install went fine until...
When my AVR bit the dust recently I took the opportunity to upgrade my projector to an LS11000 to gain 4K. Install went fine until...
It should work, but the error is in something else, but it is not yet clear what.
It should work, but the error is in something else, but it is not yet clear what.
I have MP1 TV Server 1.30 installed on Windows Server 2012R2 (with some bits added for tuner support). MP Server versions have...
