I solved it myself, by modifying the host IP-address in the server table of the database, MariaDB [(none)]> use mptvdb; Database changed MariaDB [mptvdb]> SELECT * FROM Server; +----------+----------+--------------+----------+ | idServer | isMaster | hostName | rtspPort | +----------+----------+--------------+----------+ |...

I solved it myself, by modifying the host IP-address in the server table of the database, MariaDB [(none)]> use mptvdb; Database...

Hello everyone, I'm going to need help from the community to resolve a TV server crash issue. I encountered a problem with my...

Replies: 4

Views: 771

July 16, 2024

textune

MP1 MP2 1.35 installation has deleted TuningParameters folder and xmltv.dtd file AGAIN! DE

I was installing/upgrading x64 over x86. These 2 problems did not occur when installing/upgrading x86 over x86. All is good. Now running 1.35 x86 with no problem. Thank you

I was installing/upgrading x64 over x86. These 2 problems did not occur when installing/upgrading x86 over x86. All is good. Now...

Good day, Same 2 installation problem as last version. 2 problems after upgrading to 1.35 from 1.34: 1- To avoid error message...

Replies: 1

Views: 523

September 26, 2024

Noise672

MP1 MP2 Previously recorded TV & Radio programs list, not displaying correctly. DE

First thing to say is that I use MP1, whereas I believe that you use MP2. @ge2301 has just posted that MP2 has a "folder view" in addition to the "library view", so you should be able to set up your system as I describe below, but the details will differ. In MP1, the folders that are to appear on the "Videos" panel are defined in "MP...

First thing to say is that I use MP1, whereas I believe that you use MP2. @ge2301 has just posted that MP2 has a "folder view" in...

Help Please. Yesterday upon switch-on, I had this issue with MP2: When I clicked on the [REC] icon in the following Image...

Replies: 18

Views: 1K

December 12, 2024

CyberSimian

MP1 MP2 Remote client can't access TVserver. Database issue DE

Ok, so perhaps a solution, but not the "right" solution. On the client, within media portal configuration, under TV settings, advanced options, I switched to UNC paths instead of the default RSS, and it's working very well. Sure I had to figure out the paths, but no big deal. Maybe helpful for someone in the future. Thanks for the...

Ok, so perhaps a solution, but not the "right" solution. On the client, within media portal configuration, under TV settings...

Hi folks. I have an issue with a new install/integration into my mediaportal system. I have a “mediaportal server” which has the TV...