[Approved] Australia.QLD - Toowoomba.xml (1 Viewer)

Thread starter TimK
Start date June 2, 2012

TimK

New Member

June 2, 2012

Hi,

I have attached the file for the Toowoomba area. Tested and working for me.
Can verify sources here http://ozdigitaltv.com/transmitters/QLD/178-Toowoomba

Tim

Last edited by a moderator: February 22, 2013

Sebastiii

Development Group

Team MediaPortal

February 22, 2013

Moderator
#2

Committed

Users who are viewing this thread

Similar threads

MP1 MP2 [solved] Recorded TV page count location incorrect DE

Thanks CyberSimian, that's fixed it (y) and also thanks to AJS for including the change in the next release.

When using the List Layout for Argus TV Recorded TV the page count is above the bottom information bar, refer to attached...

Replies: 4

Views: 324

April 4, 2024

DL144

MP1 MP2 "An Unknown Error Has Occurred" message when attempting to tune All subchannels of 1 TV Station DE

I have not experienced that myself, and I don't know of any reason why that might occur (but my knowledge of how TV Server works is not extensive). It is strange that you mention this because there are now four DVB-T channels in the UK that behave in the same way (this is new for the UK). I think that these might be some sort of...

I have not experienced that myself, and I don't know of any reason why that might occur (but my knowledge of how TV Server works is...

I am running MePo 1.32 X86 on Windows 11 Ryzen 9 7900X 32GB DDR5 RAM 1TB NVME Boot Drive 4TB NVME Data drive RTX 3060 12GB I have...

Replies: 10

Views: 1K

January 11, 2024

CyberSimian

MP1 MP2 Cannot connect HDHomeRun tuner DE

I've setup my HDHomeRun in MP1 as (4) IPTV cards rather than Atsc. I can see the (4) Atsc cards, but just have them disabled. I did it this way so I didn't have to edit the channel names every time tested a new TV-server install. Anyway, it works. I don't know if this would get you past the BDA driver issue. I'll provide more...

I've setup my HDHomeRun in MP1 as (4) IPTV cards rather than Atsc. I can see the (4) Atsc cards, but just have them disabled. I...

I am brand new to MediaPortal. I have installed MP 2.4.1 on Windows 10. It is a fresh install and fully up to date. I have an...

Replies: 19

Views: 1K

February 29, 2024

Dunnlor

MP1 MP2 Fanart suddenly crashing Mediaportal April 2024 DE

I had a similar issue like this that plagued me on one of my MP installs for about 4 or 5 months. Mediaportal would crash after about 20 minutes into a playlist. I finally had a thought that my screensaver was set to the same time and disabling it cured my problem. I'm pretty sure that in the past, the screensaver wouldn't engage...

I had a similar issue like this that plagued me on one of my MP installs for about 4 or 5 months. Mediaportal would crash after...

Hi, I use Mediaportal 1 a lot and have created a lot of Fanart jpegs for my music soundtracks but just in the last 2 weeks I have...