cant start MPG2 Pin ??? (2 Viewers)

ddragas

Portal Member
May 9, 2006
23
0
I get error cant start MPG2 Pin when trying to watch Sat TV from SkyStar2 DVB-S card

What does it mean?
 

Users who are viewing this thread

Similar threads

I switched back to MePo 1 some time ago, and havent really used it that much. But i wanted to watch some old movies stored as ISO file. Virtuel Clone drive is installed, and it can mount the ISO file. However when i try to select it from MePo i only get an error that i cannot mount it. [2026-06-07 14:56:35,994] [Error ] [MPMain ]...
I switched back to MePo 1 some time ago, and havent really used it that much. But i wanted to watch some old movies stored as ISO...
I switched back to MePo 1 some time ago, and havent really used it that much. But i wanted to watch some old movies stored as ISO...
Replies
0
Views
539
Reading through your code, I can see it's more than a couple steps above my paygrade. :cry:
Reading through your code, I can see it's more than a couple steps above my paygrade. :cry:
I used to run the TVService under the "NT Service\TVService" account to follow least privileges principal (not exposing my whole...
Replies
3
Views
2K
If you remember, I wrote about it when tests because of x86/x64 problems
If you remember, I wrote about it when tests because of x86/x64 problems
Hia all, So, decided to setup a new client instance and getting fed-up with the tonne of bloatware and cr*p that comes with...
Replies
9
Views
3K
Are the media/video folders on the Mint host?
Are the media/video folders on the Mint host?
I've used Mediaportal for years on a Windows Host with restricted online-access. Lately I reinstalled...
Replies
1
Views
1K
Apologies Pablik. My bad. I neglected to run WMI Manager and check Properties as you advised. Sure enough, it produced this error: I tried to run winmgmt /resetrepository, but there were conflicts with running services. So I stopped those services (Malwarebytes & IP Helper), then stopped the winmgmt service. I was then able to run...
Apologies Pablik. My bad. I neglected to run WMI Manager and check Properties as you advised. Sure enough, it produced this error...
Hi, Was using v1.33 without issue. Then started receiving error message "Unknown error occurred" when trying to watch TV. Upgraded...
Replies
7
Views
3K
Top Bottom