Disable Transitions & Animations in Skins (1 Viewer)
- Thread starter pgraju
- Start date
United Kingdom
Try using the SimpleMP skin, has very few anim's.
Hmmm, 2600 pro should cope fine though, maybe something else slowing system down.
Hmmm, 2600 pro should cope fine though, maybe something else slowing system down.
You should be able to turn of animations in setup -> general (?)
Users who are viewing this thread
Similar threads
Thank you for confirming that U&W works for you.
I ended up deleting U&W and rescanning for channels. That fixed the issue.
Thank you for confirming that U&W works for you.
I ended up deleting U&W and rescanning for channels. That fixed the issue.
I have setup Refresh DVB EPG so that BBC One is the grabber channel (which is meant to grab all available channels) but the U&W...
I see no reason in Windows XP or 7, in my experience, on ancient Atom, Windows 10 worked faster than XP or 7...
I see no reason in Windows XP or 7, in my experience, on ancient Atom, Windows 10 worked faster than XP or 7...
Hi all, I'm new to MediaPortal and looking forward to using it. Just one catch and I apologize if it sounds silly - I want to run...
Fixed, I think.
Certainly the vintage MP2 installer that I was using no longer installs the LAV filters. I can only assume that these were never part of the install package itself, but rather downloaded during the install, and that link no longer exists. Shame that the installer doesn't indicate this.
Last time when I installed the...
Fixed, I think.
Certainly the vintage MP2 installer that I was using no longer installs the LAV filters. I can only assume that...
Hi all,
I've recently retired my MP2 setup for my main HTPC and gone back to separates, but I wanted to retain the ability to play...
4.5 is really old. I'm not sure 4.5.5 even is a version that actually existed. You should be able to install .NET Framework 4.8.0 on Windows 7 SP1
4.5 is really old. I'm not sure 4.5.5 even is a version that actually existed. You should be able to install .NET Framework 4.8.0...
My TV PC is more a cast-off on older hardware (a 'Quiet PC' i5 4690, 16GB ram, 2xSSD 1xHDD, system graphics), mainly as a cheap way...
When my AVR bit the dust recently I took the opportunity to upgrade my projector to an LS11000 to gain 4K. Install went fine until I switched to my HTPC which is my primary source. When I switch to the HTPC the screen goes blank for a long time and then I have sound, no picture, and in the lower left hand corner:
"Source: HDMI 1
Not...
When my AVR bit the dust recently I took the opportunity to upgrade my projector to an LS11000 to gain 4K. Install went fine until...
When my AVR bit the dust recently I took the opportunity to upgrade my projector to an LS11000 to gain 4K. Install went fine until...