[confirm] Mediaportal has wrong size after resume (2 Viewers)

zator

Portal Member
August 19, 2009
31
0
Home Country
Denmark Denmark
I recently updated to RC4 and am now experiencing the same problems as in RC1 where the screen size would sometimes be 3/4 of the screen. This was fixed in both RC2 and RC3, but appears to be back again or is it just me?
 

zator

Portal Member
August 19, 2009
31
0
Home Country
Denmark Denmark
Weird I never had this problem in RC2 or RC3. Maybe I was just lucky :/
 

RoChess

Extension Developer
  • Premium Supporter
  • March 10, 2006
    4,434
    1,897
    Verify overscan is set to 0% in Catalyst Control Center, I found out recently that HDMI driven devices are sometimes reporting themselves back as analog (since most support both), making the overscan setting kick in when normally this shouldn't happen for digital devices.
     

    thesystemera

    Portal Pro
    May 26, 2008
    810
    22
    42
    Auckland
    Home Country
    New Zealand New Zealand
    I have seen this happen, but only through HDMI as far as I can tell, my other system which is identical run's through a VGA output and does not have this problem, or I just have not seen it yet.. The HDMI one is quite rare...
     

    msj33

    MP Donator
  • Premium Supporter
  • November 30, 2005
    471
    76
    Home Country
    England England
    I also confirm this issue.

    Running ATI + HDMI-HDMI

    I have Onkyo Receiver.
     

    gryphonnz

    Portal Member
    June 30, 2007
    5
    0
    Home Country
    New Zealand New Zealand
    I'm having the same problem, and not just after resume - any time I turn my TV and reciever off, the problem can happen.

    My setup is
    PC [DVI] -> [HDMI] Onkyo TX-507 [HDMI] -> [HDMI] TV

    Signal is 1080P the whole way.

    If I power on the TV, then the reciever, about 50% of the time MP comes back correctly, and the other 50% it is in the top left 1/4 of the screen.
     

    Users who are viewing this thread

    Top Bottom