No free card available (1 Viewer)
- Thread starter beatnut88
- Start date
- September 1, 2008
- 21,544
- 8,236
- Home Country
-
New Zealand
Elementary dear Homes! 
A problem occurred when you scanned for channels at about 7pm. Basically bad timing. You had a schedule set to record at around the same time. The scan and schedule recording processes fought over the tuners, and they both lost.
Restart the TV service and everything should work again.
A problem occurred when you scanned for channels at about 7pm. Basically bad timing. You had a schedule set to record at around the same time. The scan and schedule recording processes fought over the tuners, and they both lost.
Restart the TV service and everything should work again.
Users who are viewing this thread
Similar threads
Maybe [News] - MediaPortal 1.33 Pre-Release with new x64 version ready for testing
Maybe [News] - MediaPortal 1.33 Pre-Release with new x64 version ready for testing
After a long time I built a new HTPC. Everything went well. Just one problem. I imported the old recordings and can see them in the...
I compliment you on the thoroughness of your investigations. (y)
Unfortunately, I don't have any ideas what the problem might be. :(
Perhaps someone else will post with some suggestions. :unsure:
-- from CyberSimian in the UK
I compliment you on the thoroughness of your investigations. (y)
Unfortunately, I don't have any ideas what the problem might be...
Would appreciate it if someone could solve (or point me in the right direction to resolve) this issue.
I have “MultiSeat”...
I have also had this problem in the past. There are two components to this problem:
Your internet router is pinging the HTPC at regular intervals in order to see if the HTPC is still present on the network.
The network adapter in the HTPC has "Wake on Lan" enabled. So at the end of a recording, the HTPC transitions from away mode to...
I have also had this problem in the past. There are two components to this problem:
Your internet router is pinging the HTPC at...
Nachdem ich mp 1.38 neu installiert habe klappt soweit alles wie früher. Ein Problem besteht aber und das ist Standby nach einer...
When i was using 2.5, and like im using MP1, i set the resolution of my desktop. And MEPo just uses whatever i have set.
When i was using 2.5, and like im using MP1, i set the resolution of my desktop. And MEPo just uses whatever i have set.
MP 2.5 does not recognize my Bravia 32S5100 as 1920x1080 but only as 1280x720. The PC's monitor is recognized as 1920x1080. Both...
two simultaneous recordings succeeded. All good!
two simultaneous recordings succeeded. All good!
Since upgrading from 1.36 to 1.38, MP1 no longer connects to my tuners. They no longer appear under the server in the left-hand...