Just to be clear, I am talking about the GitHub access to the source code - using the Code button. I noticed that there is a link 'MediaPortal 1.36 Release' at the right-hand side of the page that takes me to page that has a link to the source code at the bottom of the page. That link seems to be virus free (according to Windows 10)...

Just to be clear, I am talking about the GitHub access to the source code - using the Code button. I noticed that there is a link...

I have tried to download the MediaPortal-1 of vs 1.36 source code and Windows 10 is saying it contains a virus. I have never had a...

Replies: 1

Views: 922

December 8, 2024

Anthony Vaughan

MP1 MP2 Too many requests and error 429 DE

Maybe the server is/was too busy when you tried to authenticate. I occasionally run into that too, also with the opensubtitles api I regularly get 429's... there isn't much that can be done about it, except making sure the software isn't hammering the service and having patience...

Maybe the server is/was too busy when you tried to authenticate. I occasionally run into that too, also with the opensubtitles api...

Hello, Hello, when I try to authorize trakt configuration for mediaportal using the trakt plugin, I get the following error...

Replies: 1

Views: 270

October 26, 2025

doskabouter

MP1 MP2 1.34 Cannot use MP as source for LS11000 laser projector DE

When my AVR bit the dust recently I took the opportunity to upgrade my projector to an LS11000 to gain 4K. Install went fine until I switched to my HTPC which is my primary source. When I switch to the HTPC the screen goes blank for a long time and then I have sound, no picture, and in the lower left hand corner: "Source: HDMI 1 Not...

When my AVR bit the dust recently I took the opportunity to upgrade my projector to an LS11000 to gain 4K. Install went fine until...

Replies: 0

Views: 735

August 4, 2024

errfoil

MP1 MP2 MP2 - V2.3 Difference between using specific audio renderer versus "Default WaveOut Device"? DE

Sorry, it's my fault -- I did not notice that you are using MP2. :( MP1 has a separate configuration utility, similar to "TV Server Config". I have tried MP2 only a couple of times, and have never used it seriously. I don't know what MP2 supports with regard to adjusting audio delay, but I do know that all of the adjustments of...

Sorry, it's my fault -- I did not notice that you are using MP2. :( MP1 has a separate configuration utility, similar to "TV...

Hi. I recently upgraded my home cinema AVR which also meant changed from sending audio from my HTPC as 5.1 using optical to 7.1...