- Thread starter
- #41
Hi bozzo870,
It is not that difficult to configure it. Here are a few steps to follow. I'm not sure it is complete since I'm not at home and can check in detail. I've attached my zipped installation as a reference (but stripped out the executable due to size limitations in this forum):
1. Disable webEPG in MP Config, but keep the wakeup time in TVServer Config
2. Create a .bat file with the grabber-command, see grabEPG.bat. Store TVGuide.xml in the same place as webepg.exe used to do.
3. Create a config file for xmltv what channels to download, should be in the .xmltv folder, see tv_grab_se_swedb.conf. I've set it up to grab only the FTA channels.
4. Run the grabber once to get some data.
5. Make sure the TV-channel to EPG-channel mapping is updated in TVServer config.
6. Create a scheduled activity from the Control Panel to start xmltv.exe at the same time as webepg used to run.
That should do the trick.
Let me know if you have any questions!
/Peter
It is not that difficult to configure it. Here are a few steps to follow. I'm not sure it is complete since I'm not at home and can check in detail. I've attached my zipped installation as a reference (but stripped out the executable due to size limitations in this forum):
1. Disable webEPG in MP Config, but keep the wakeup time in TVServer Config
2. Create a .bat file with the grabber-command, see grabEPG.bat. Store TVGuide.xml in the same place as webepg.exe used to do.
3. Create a config file for xmltv what channels to download, should be in the .xmltv folder, see tv_grab_se_swedb.conf. I've set it up to grab only the FTA channels.
4. Run the grabber once to get some data.
5. Make sure the TV-channel to EPG-channel mapping is updated in TVServer config.
6. Create a scheduled activity from the Control Panel to start xmltv.exe at the same time as webepg used to run.
That should do the trick.
Let me know if you have any questions!
/Peter