WMV and Yahoo (1 Viewer)
- Thread starter raphael
- Start date
Poland
Users who are viewing this thread
Similar threads
Default Direct Sound Device was the problem.
MPAR worked better than Dircect Sound, but is still a problem.
Changed Audio Renderer to use the TV and it's working.
Default Direct Sound Device was the problem.
MPAR worked better than Dircect Sound, but is still a problem.
Changed Audio Renderer...
New computer build with Windows 11 Pro.
MediaPortal 1.34 x64.
When I pause a video the audio drops out. This only occurs when...
When my AVR bit the dust recently I took the opportunity to upgrade my projector to an LS11000 to gain 4K. Install went fine until I switched to my HTPC which is my primary source. When I switch to the HTPC the screen goes blank for a long time and then I have sound, no picture, and in the lower left hand corner:
"Source: HDMI 1
Not...
When my AVR bit the dust recently I took the opportunity to upgrade my projector to an LS11000 to gain 4K. Install went fine until...
When my AVR bit the dust recently I took the opportunity to upgrade my projector to an LS11000 to gain 4K. Install went fine until...
I was installing/upgrading x64 over x86.
These 2 problems did not occur when installing/upgrading x86 over x86.
All is good. Now running 1.35 x86 with no problem.
Thank you
I was installing/upgrading x64 over x86.
These 2 problems did not occur when installing/upgrading x86 over x86.
All is good. Now...
Good day,
2 problems after upgrading to 1.34 from 1.33:
1- To avoid error message TuningParameters not found when starting...
Nice you could resolve the issue!
Nice you could resolve the issue!
I have MediaPortal 2.5 Server installed on one computer and Mediaportal 2.5 client on another.
The client is connected to the...
Ran into this problem following an otherwise sucessful upgrade from MP 1.34 x64 to MP 1.35 x64 the CEC Remote plugin which I use just to control volume and standby, will no longer put my devices (TV & AVR) to sleep when the HTPC is put in standby. Also when I wake up the HTPC MP closes or crashes (not sure which) as per the example in...
Ran into this problem following an otherwise sucessful upgrade from MP 1.34 x64 to MP 1.35 x64 the CEC Remote plugin which I use...
Ran into this problem following an otherwise sucessful upgrade from MP 1.34 x64 to MP 1.35 x64 the CEC Remote plugin which I use...