Ati remote (1 Viewer)

Thread starter elec999
Start date February 10, 2007

elec999

New Member

February 10, 2007

I need help with my ati remote to map the next and backwards buttons, whole watching videos.
To go to the next video and previous video.
Thanks

Users who are viewing this thread

Similar threads

MP1 MP2 An installation report - older hardware and why I used 1.33 not 1.38 DE

4.5 is really old. I'm not sure 4.5.5 even is a version that actually existed. You should be able to install .NET Framework 4.8.0 on Windows 7 SP1

4.5 is really old. I'm not sure 4.5.5 even is a version that actually existed. You should be able to install .NET Framework 4.8.0...

My TV PC is more a cast-off on older hardware (a 'Quiet PC' i5 4690, 16GB ram, 2xSSD 1xHDD, system graphics), mainly as a cheap way...

Replies: 5

Views: 2K

December 30, 2025

el Filou

MP1 MP2 Server and client work but remote clients fail DE

Thank you for this tip! I'm moving MP TV Server to a new machine. I installed the 64-bit version and most of the MP firewall rules were set to Public. I couldn't connect to the new TV Server from my old single-seat installation running 32-bit until I changed all MP-related firewall rules on the new machine to Private. Before I did...

Thank you for this tip! I'm moving MP TV Server to a new machine. I installed the 64-bit version and most of the MP firewall...

Server and client on modern uptodate Windows 11 desktop. Software is Server and Client version x86 1.38.003 Remote client on...

2 3

Replies: 26

Views: 2K

Thursday at 05:33

mrceolla

MP1 MP2 Scanning & Mapping channels DE

I note that you are using MP2. The following applies to MP1, but I think that MP2 is identical in this situation. "TV Server Config" has a "TV Mapping" panel in the "TV Channels" section. On the "TV Mapping" tab: The left column lists the channels that have not yet been mapped to the TV tuner identified by the drop-down menu just...

I note that you are using MP2. The following applies to MP1, but I think that MP2 is identical in this situation. "TV Server...

I've scanned for channels, and got all channels mapped to tuner 0 of my 8 channel TV card (eg: 2 cards of 4 channels each) Is there...