PCI Remote (1 Viewer)

Marcusb

Retired Team Member
  • Premium Supporter
  • February 16, 2005
    1,994
    29
    Melbourne
    Most of the remotes that plug into the tv card itself will not work with MP unless someone has already taken the trouble to build in support. You can check the HIP website to see if yours has been set up already (www.byremote.net I think) but in my view you are much better off spending the AU$69 to buy an MCE remote. It's much more user friendly than most remotes and is supported right out of the box with MP, although you'll have to do a little more work if you are unning WinXP Home.
     

    Users who are viewing this thread

    Similar threads

    Actually I solved this myself. I did have the correct driver (it was the only one which would work). But on the drivers download page, there was an additional item called "TBS6281se V2 Change Mode Tool". There was zero documentation to accompany this. I downloaded it and ran it. It is a tool to detect the current run state of both...
    Actually I solved this myself. I did have the correct driver (it was the only one which would work). But on the drivers download...
    My previous TBS PCI-E card failed, so I bought another one. The model I chose is the TBS 6181-SE, which can be seen on Amazon here...
    Replies
    2
    Views
    1K
    4.5 is really old. I'm not sure 4.5.5 even is a version that actually existed. You should be able to install .NET Framework 4.8.0 on Windows 7 SP1
    4.5 is really old. I'm not sure 4.5.5 even is a version that actually existed. You should be able to install .NET Framework 4.8.0...
    My TV PC is more a cast-off on older hardware (a 'Quiet PC' i5 4690, 16GB ram, 2xSSD 1xHDD, system graphics), mainly as a cheap way...
    Replies
    5
    Views
    2K
    Thank you for this tip! I'm moving MP TV Server to a new machine. I installed the 64-bit version and most of the MP firewall rules were set to Public. I couldn't connect to the new TV Server from my old single-seat installation running 32-bit until I changed all MP-related firewall rules on the new machine to Private. Before I did...
    Thank you for this tip! I'm moving MP TV Server to a new machine. I installed the 64-bit version and most of the MP firewall...
    Server and client on modern uptodate Windows 11 desktop. Software is Server and Client version x86 1.38.003 Remote client on...
    Replies
    26
    Views
    2K
    Thanks CyberSimian, will give it a try!
    Thanks CyberSimian, will give it a try!
    I have recently installed mediaportal 1 and all is working fine, however I would like the startup page to be the TV guide. I guess...
    Replies
    2
    Views
    2K
    Reading through your code, I can see it's more than a couple steps above my paygrade. :cry:
    Reading through your code, I can see it's more than a couple steps above my paygrade. :cry:
    I used to run the TVService under the "NT Service\TVService" account to follow least privileges principal (not exposing my whole...
    Replies
    3
    Views
    2K
    Top Bottom