remove channels (1 Viewer)
- Thread starter M13P
- Start date
Netherlands
a rather drastic approach is:
got to sqlserver management studio, log on and drop the tvlibrary....
got to sqlserver management studio, log on and drop the tvlibrary....
Users who are viewing this thread
Similar threads
Thankyou High_Five, that worked perfectly, I now remember doing that 10 years ago, thanks for jogging my old memory. Cheers Tony
Thankyou High_Five, that worked perfectly, I now remember doing that 10 years ago, thanks for jogging my old memory. Cheers Tony
Hi everyone,
I have been using it For 16 years now (from V1.1.1) and it has worked flawlessly.
I only use TV Series and Moving...
Fixed, I think.
Certainly the vintage MP2 installer that I was using no longer installs the LAV filters. I can only assume that these were never part of the install package itself, but rather downloaded during the install, and that link no longer exists. Shame that the installer doesn't indicate this.
Last time when I installed the...
Fixed, I think.
Certainly the vintage MP2 installer that I was using no longer installs the LAV filters. I can only assume that...
Hi all,
I've recently retired my MP2 setup for my main HTPC and gone back to separates, but I wanted to retain the ability to play...
Sorted, it is a Rating flag that I have never seen before, silly me !!
Cheers Tony
Sorted, it is a Rating flag that I have never seen before, silly me !!
Cheers Tony
I have just done a clean install of v1.36.
Current setup
Media Portal 1.36
Titan skin (only classic home)
TV Series 4.5.1.737...
Thank you for confirming that U&W works for you.
I ended up deleting U&W and rescanning for channels. That fixed the issue.
Thank you for confirming that U&W works for you.
I ended up deleting U&W and rescanning for channels. That fixed the issue.
I have setup Refresh DVB EPG so that BBC One is the grabber channel (which is meant to grab all available channels) but the U&W...
I note that you are using MP2. The following applies to MP1, but I think that MP2 is identical in this situation.
"TV Server Config" has a "TV Mapping" panel in the "TV Channels" section. On the "TV Mapping" tab:
The left column lists the channels that have not yet been mapped to the TV tuner identified by the drop-down menu just...
I note that you are using MP2. The following applies to MP1, but I think that MP2 is identical in this situation.
"TV Server...
I've scanned for channels, and got all channels mapped to tuner 0 of my 8 channel TV card (eg: 2 cards of 4 channels each)
Is there...
