Change position of "Now playing" in the lower left corner (1 Viewer)

PussyWagon

Portal Pro
August 2, 2008
235
7
Which xml file do i need to change to move the Album view "Now plays" that appears in the lower left corner when music is playing and you are in home screen?

regards
 

Users who are viewing this thread


Write your reply...

Similar threads

My knowledge of programming is limited, but the logic in this seems to confirm what I thought, thank you.
My knowledge of programming is limited, but the logic in this seems to confirm what I thought, thank you.
Good evening, Does anybody know the mouse position (Ypos coordinate) below which the topbar activates. I seem to remember there...
Replies
5
Views
899
When my AVR bit the dust recently I took the opportunity to upgrade my projector to an LS11000 to gain 4K. Install went fine until I switched to my HTPC which is my primary source. When I switch to the HTPC the screen goes blank for a long time and then I have sound, no picture, and in the lower left hand corner: "Source: HDMI 1 Not...
When my AVR bit the dust recently I took the opportunity to upgrade my projector to an LS11000 to gain 4K. Install went fine until...
When my AVR bit the dust recently I took the opportunity to upgrade my projector to an LS11000 to gain 4K. Install went fine until...
Replies
0
Views
514
Nice finding! (y)(y)(y) Adapted to new DWHD and PVHD ;) Position is in front of category bar ;)
Nice finding! (y)(y)(y) Adapted to new DWHD and PVHD ;) Position is in front of category bar ;)
This thread is intended for skin authors, plus those advanced users who have learnt skin programming and have customised the skins...
Replies
1
Views
741
You can always use GitHub online But judging by the picture, you are doing well. Direct Push to Master is prohibited, create PR.
You can always use GitHub online But judging by the picture, you are doing well. Direct Push to Master is prohibited, create PR.
Hello, Because I was annoyed with closing MP, launch config, modify setting and start MP again, I decided to give MP the ability...
Replies
5
Views
3K
Attached are new TV service logs with your latest DLL. I see lots of EPG events and none of the messages from earlier. Congratulations!
Attached are new TV service logs with your latest DLL. I see lots of EPG events and none of the messages from earlier. Congratulations!
I have some weird behavior trying to operate the MP GUI in a new installation of MP 1.36 under Windows 11 Pro. Some of the remote...
Replies
33
Views
2K
Top Bottom