Compiling anysee branch from GitHub (2 Viewers)

[jehe]

Thank you,
Jean

 

[Denny09]

Would it possible to also have a installer link I would like to test it. I have anysee e7 s2 card and I subscribe to euroworldnetworks which use irdeto2 cam. Thank you

 

[jehe]

Hello mm,

After I have watched a time to a film through moving pictures (Thank you Sebastiii for the Blu-ray patch for moving pictures), I have then switch to TV (without stopping the movie) at this moment I had no TV signal. This was about 20.45 H.
After a windows restart I had back TV signal.
Don't know if this has to do with the TV server or with the various plugins that I have installed.

A little more control about the epg would also be welcome.

Jean

 

[mm1352000]

Hello Jean

Thanks for the feedback!
In the logs it seems like your E7 S2 is working well but your E30 S2 is not. All of the tuning failures in the logs are with the E30 S2; in fact I don't see any successful tunes with the E30...

So to confirm

...I have then switch to TV (without stopping the movie) at this moment I had no TV signal. This was about 20.45 H

In this case the E30 was used, and it failed.

After a windows restart I had back TV signal.

In this case the E7 was used, and it succeeded.

Don't know if this has to do with the TV server or with the various plugins that I have installed.

I don't see any obvious problems...

A little more control about the epg would also be welcome.

Can you be more specific?
For example, do you mean:
- control over grabbing times
- control over which tuners are used
- control over which channels are used for grabbing

mm

 

[jehe]

Hello mm,
Sorry for the delayed response (day trip to the sea).
I think this is partly my fault, I have the E7 just looped through to the E30 (too lazy to lay a second cable to the dish ), I thought that when the first TV card faild the other would take over.
So I thought wrong, the E7 was probably busy with the epg, then I put the TV on and the tvserver switches to E30, which was not possible because the LNB was in use.
So I'll turn off the E30.

Can you be more specific?
For example, do you mean:
- control over grabbing times
- control over which tuners are used
- control over which channels are used for grabbing

Yes those are the things where a bit more control should be.
A search function would also be welcome.
Or a plugin for the epgcollector software is also a good alternative.
no feature request here!


Jean

Ps: I'm not too lazy, but looking for good (3rd) TV card, any suggestions are welcome.

 

[jehe]

Hello,

Sometimes I get the message "All Cards Busy" while I have no recordings going on.
Everything returns to normal after a restart (windows).
So I have something set wrong?
I have enabled "epg grabbing while timeshifting/recording"?

Jean

 

[mm1352000]

Hello Jean

The problem is caused by a known deadlock issue with TsWriter. Please try to disable the idle EPG grabber.

mm

 

[jehe]

Hello mm,

At first sight that was the solution, if not I report back.

Once again thank you,
Jean

 

[killer8]

Where to find the installer for this version with anysee support? I have an anysee e30tcplus and an anysee e7tc plus and would like to try it.

Thank you

 

[mm1352000]

Hello killer8

I have not released an official installer, but I could PM you with a link if you want to test (official support not provided). Please keep in mind that the smartcard slot is not supported. Do you still want to test?

mm