[solved] General HID no 0 key. (1 Viewer)

[azzuro]

Sorry. I don't have mce receptor.
Only imon usb receiver. And for this one i use irss.
And I think using imon manager with mce remote send only shortcut but not official hid key.

 

[Sebastiii]

@Stéphane Lenclud

I have installed a older version with HID / MCE tab and i can't have 0 to 9 with MCE too
I need to install an very older MP version without HID rework to fully confirm

 

[Stéphane Lenclud]

I would not bother it's always been like that with azerty

 

[Sebastiii]

I would not bother it's always been like that with azerty

You are right MCE 0 to 9 only working when cpas lock is enable on my French keyboard.
So maybe @regeszter is a different issue than me

So maybe a feature can be done for this ?

Thanks

 

[Stéphane Lenclud]

So maybe a feature can be done for this ?

It could be tricky to implement since we would have to touch of keyboard handler but that should be doable.

 

[The_Stig]

Hrm, not sure if I understand this right, upgraded to 1.13 too and now have the HID instead of MCE. And running in quite some problems. One is related to the digits question: I manually configured the "0" to delete e.g. recordings. How would I do this now?

 

[HTPCSourcer]

I manually configure the "0" to delete e.g. recordings.

This is the standard behavior, it should work without any customization. It does for me.

Please enable extensive logging in the MP remote section and post logs for further diagnosis. You can then see what code is sent by the remote and how MP responds to it.

 

[The_Stig]

Thanks, will do when I am at home again.

 

[Stéphane Lenclud]

Thanks, will do when I am at home again.

Open a new thread for each specific issue you may have.

 

[The_Stig]

Open a new thread for each specific issue you may have.

Will do, have to get into the new naming of HID I guess.