Hover 3d-model? (1 Viewer)
- Thread starter ELba
- Start date
Germany
Users who are viewing this thread
Similar threads
Actually I solved this myself. I did have the correct driver (it was the only one which would work). But on the drivers download page, there was an additional item called "TBS6281se V2 Change Mode Tool". There was zero documentation to accompany this. I downloaded it and ran it. It is a tool to detect the current run state of both...
Actually I solved this myself. I did have the correct driver (it was the only one which would work). But on the drivers download...
My previous TBS PCI-E card failed, so I bought another one. The model I chose is the TBS 6181-SE, which can be seen on Amazon here...
The only configuration that is certain to work is when the MP client and MP server are from the same release.
It is sometimes possible to use MP clients from a release that is different to the MP server, but whether it works depends on the specific changes that were made between the two releases.
-- from CyberSimian in the UK
The only configuration that is certain to work is when the MP client and MP server are from the same release.
It is sometimes...
Before you create this bug report:
Make sure that your system (Windows, codecs and drivers) is up to date, matching the...
Before you create this bug report:
Make sure that your system (Windows, codecs and drivers) is up to date, matching the Requirements and you've filled in your System Specs.
Have a look at our MediaPortal Wiki! Maybe the solution is already there.
Have a look at our Jira (Bug and Issue Tracker)and the threads in this section, maybe...
Before you create this bug report:
Make sure that your system (Windows, codecs and drivers) is up to date, matching the...
Before you create this bug report:
Make sure that your system (Windows, codecs and drivers) is up to date, matching the...
This solves the problem. Thank you. I completely overlooked that.
This solves the problem. Thank you. I completely overlooked that.
I'm trying to register Mediaportal as new application in trakt. When I'm ordering a new user code the window shown only "USERCODE"...
When they added it, they forgot to add it to the settings.
When they added it, they forgot to add it to the settings.
I wanted to turn off all Zoom modes except Normal, Zoom and Stretched, so I did in Configuration. But as Cinema scope is not...
