[WiP] madVR support in MP1 (87 Viewers)

[Sebastiii]

It's faster when i set an IP based on my current network, so it seems to failed to do the connection to the TV on your side @joecrow but no clue why

 

[joecrow]

It's faster when i set an IP based on my current network, so it seems to failed to do the connection to the TV on your side @joecrow but no clue why

Any suggestion how/where to change the IP and to what, MP Config is closed as soon as I try to configure Auto3D, so I'm kinda stuck.

 

[Sebastiii]

The IP is in mediaportal.xml because when using yours all was set with the IP in Auto3D
So open that file and search for the IP and removed it, i think it should works

 

[joecrow]

So open that file and search for the IP and removed it, i think it should works

Got it, fixed it, thanks. Now I can start again on trying to get it working.

 

[Freuli]

Hi Sebastiii,

v445 stays black after switching the AVR off. On is working perfectly. Unfortunately I didn't store a log file yesterday. I went back to v444.

Regards
Markus

 

[Sebastiii]

@Freuli hi
Are you able to test this bin : [WiP] - madVR support in MP1 ?
Thanks.

 

[joecrow]

OK I got Auto3D working, well sort of (needs some refining). Basically I had to enable DMR in the network settings of the Philips TV then using the actual IP address for the TV in the Auto3D config with jointSpace v1 (the only option that really connects to my TV). It was then possible to generate and execute a command sequence but as per this post it was made difficult since the jointsSace v1 option does not have a 3D button although the TV remote does and so the sequence is much longer and clunkier than necessary.
UPDATE:-
Auto3D is detecting a 3DSBS and now automatically switching the TV to 3DSBS mode, however on stop it looks like a (non customizible) command sequence is triggered that does not work with the result that the TV is not returned to 2D mode and the MP GUI is not displayed correctly, still working on it.

 

[Freuli]

Hi Sebastiii,

446 is working perfectly! I started several times from standby, switched the AVR on and off, started Video with TV and with AVR and also wit and without bitstreaming. Even bitsreaming with TV didn't cause a hang up.

Well done!

regards
Markus

 

[Sebastiii]

Nice @Freuli logs looks good thanks.

 

[daWooky]

hi @Sebastiii
so far all good with v446 on my side too... runs with fcu image on test rig also with new lav/mad
mepo fcu option still needed
that new strg+s mad shortcut is quit useful...see new madvr 1050ti settings